Abstract:Due to the energy crisis and environmental pollution, the installed capacity of inverter-based resources (IBRs) in power grids is rapidly increasing, and grid-following control (GFL) is the most prevalent at present. Meanwhile, grid-forming control-based (GFM) devices have been installed in the grid to provide active support for frequency and voltage. In the future GFL devices combined with GFM will be promising, especially in power systems with high penetration or 100% IBRs. When a short-circuit fault occurs in the grid, the controlled current source characteristic of the GFL devices leads to insufficient dynamic voltage support (DVS), while the GFM devices usually reduce the internal voltage to limit the current. Thus, deep voltage sags and undesired disconnections of IBRs may occur. Moreover, due to the dispersed locations and the control strategies' diversity of IBRs, the voltage support of different devices may not be fully coordinated, which is not conducive to short-term voltage security (STVS). To address this issue, a control scheme based on the simulation of transient characteristics of synchronous machines (SMs) is proposed. Then, a new fault ride-through strategy (FRT) is proposed based on the characteristic differences between GFL and GFM devices, and an optimization model of multi-device control parameters is formulated to meet the short-term voltage security constraints (SVSCs) and device capacity constraints. Finally, a fast solution method based on analytical modeling is proposed for the model. Test results based on the doublegenerator-one-load system, the IEEE 14-bus system, and other systems of different sizes show that the proposed method can effectively enhance the active support capability of GFL and GFM to the grid voltage, and avoid the large-scale disconnection of IBRs

High Share Participation of Grid-Forming InverterBased Resources in Grid Frequency and Voltage Support

Small Signal Synchronization Stability Analysis of Interconnected System Containing Grid-Forming and Grid-Following Converters from the Perspective of Dual-axis Synchronous Generator

An Adaptive Inertia Control to Improve Stability of Virtual Synchronous Machines under Various Power Grid Strength

Active Support of Inverters for Improving Short-Term Voltage Security in Power Systems with 100% Inverter-based Resources

Active Support of Inverters for Improving Short-Term Voltage Security in 100% IBRsPenetrated Power Systems

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Grid-Forming Control for DFIG Based Wind Farms to Enhance the Stability of LCC-HVDC

A Review of Recent Requirements for Inverter-Based Resources and Grid-Forming Technologies

Grid‐forming control for inverter‐based resources in power systems: A review on its operation, system stability, and prospective

Extended Characteristics of Grid-Forming Control: Seen from the Perspective of AC Power Supply

Guest Editorial: Grid‐forming Converters Placement and Utilisation to Enhance Transmission and Distribution Performances under High Penetration of Inverter‐based Resources

Analysis of Grid-Forming Inverter Controls for Grid-Connected and Islanded Microgrid Integration

Evaluating Frequency Stability with a Generic Model for IBR Penetration and the Implementation of Grid-Forming Control Strategies

Virtual Impedance Control for Enhancing the Inertia Provision of Grid-forming Doubly-fed Induction Generator

Virtual Synchronous Control for Grid-Connected DFIG-Based Wind Turbines

Grid Forming Technologies to Improve Rate of Change in Frequency and Frequency Nadir: Analysis-Based Replicated Load Shedding Events

An Extension of Grid-Forming: A Frequency-Following Voltage-Forming Inverter

On the control interaction of synchronous machine and inverter-based resources during system-split situations

Grid-Forming Converters control based on DC voltage feedback

Control of Grid-Forming VSCs: A Perspective of Adaptive Fast/Slow Internal Voltage Source

Internal Energy Based Grid-Forming Control for MMC-HVDC Systems With Wind Farm Integration