Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

Active Power Enhancement Control Strategy of Grid-Forming Inverters Under Asymmetrical Grid Faults

A Low-Voltage Ride-Through Control Strategy for Three-Phase Grid-Connected Pv Systems

A Systematic Approach Via IIR Filters for Enhancing the Robustness of LCL-Type Shunt Active Power Filters to Grid Impedance

Current Control of LCL-Type Shunt APFs: Damping Characteristics, Stability Analysis, and Robust Design Against Grid Impedance Variation

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

Active Power and Voltage Cooperative Control for Improving Fault Ride-Through Capability of Grid-Forming Converters

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

An Improved Current-Limiting Control Strategy of Grid-Forming Inverter During Grid Fault

Voltage Support Capability Analysis of Grid-Forming Inverters with Current-Limiting Control Under Asymmetrical Grid Faults

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

Redundant Module Based Control Scheme for Grid-Forming Cascaded H-Bridge PV Converters to Enhance Overcurrent Capability

Improved Virtual Synchronous Generator Control of DFIG to Ride-Through Symmetrical Voltage Fault

Control strategy for current limitation and maximum capacity utilization of grid connected PV inverter under unbalanced grid conditions

Enhancing grid-connected inverter performance under non-ideal grid conditions: a multi-functional multiplexing control strategy

Protected control strategies for voltage-source-converter (VSC) under grid faults in AC/DC hybrid grid

Cross-Forming Control and Fault Current Limiting for Grid-Forming Inverters

Optimal short‐circuit current control of the grid‐forming converter during grid fault condition

Coordinated-Control Strategy of Photovoltaic Converters and Static Synchronous Compensators for Power System Fault Ride-Through

Current-Synchronization Control of Grid-Forming Converters for Fault Current Limiting and Enhanced Synchronization Stability

Enhancement of Low-Voltage Ride-Through Capability for Virtual Synchronous Generators Based on Virtual Impedance Voltage Control