Three routes to superinsulating silica aerogel powder
Ana Stojanovic,Shanyu Zhao,Emanuele Angelica,Wim J. Malfait,Matthias M. Koebel
DOI: https://doi.org/10.1007/s10971-018-4879-4
2019-01-11
Abstract:Silica aerogel is the archetypal thermal superinsulator and commonly applied to improve the thermal performance of on- and off-shore industrial infrastructure and buildings. Hitherto, the main products on the market are silica aerogel based blankets fabricated by casting a silica sol into a porous or fiber matrix, followed by gelation, hydrophobization, and (supercritical) drying. Considering the diffusion efficiency of the reagents and solvents used in the preparation, a reduced size of the gel bodies may accelerate and simplify the sol-gel, hydrophobization, and drying processes. Thus, particle based products, derived from silica aerogel granulate and powder additives and semi-finished products, are an attractive solution towards inexpensive aerogel applications. Here, we optimized the process parameters for silica aerogel powder production from three common silica precursors: waterglass (WG), ion-exchanged waterglass, and tetraethoxysilane (TEOS), including gelation pH, hydrophobization procedure, solvent system, processing temperatures, and ambient pressure drying protocol. Successful hydrophobization is confirmed by elemental analysis, FTIR and quantitative solid-state NMR spectroscopy. All three routes lead to silica aerogel powders with similar type IV isotherms, and BET surface areas above 700 m2/g. Importantly, the thermal conductivity of the packed powder beds does not exceed 20 mW/(m⋅K) for all three routes, implying even lower thermal conductivities of the aerogel phase itself. Total processing time, including gelation, aging, surface modification, and ambient pressure drying is between 2 and 4 h, depending on the selected route. Given that high quality silica aerogel powders can be produced from all investigated silica precursors and hydrophobization agents, the process selection for industrial upscaling can be based entirely on engineering and economic considerations.
materials science, ceramics