Preparation and Characterization of Composite SiO2 Aerogel by a Novel One-step Modified Process
Guangwu LIU,Bin ZHOU,Xingyuan NI,Yangang LIU
DOI: https://doi.org/10.14062/j.issn.0454-5648.2015.07.13
2015-01-01
Abstract:A composite of silica hydrogel with ceramic fibers (15% in mass fraction) was synthesized with sodium silicate as a precursor and deionized water as a solvent by a sol?gel method, and the composite was subsequently modified with a solution of ethanol/trimethylchlorosilane/n-hexane via one-step solvent exchange and surface modification, thus obtaining the crack-free and high hydrophobic composite aerogel monoliths. The composite aerogel has a low density of 0.216 g/cm3 and a superior formability. The ceramic fibers can be dispensed into the sample and combined with the silica aerogel network. There is a spongy meshwork structure on the surface of the aerogel. The aerogel samples were characterized by microstructure, analysis, specific surface area measurement, thermogravimetric analysis, hydrophobicity, elastic modulus and thermal conductivities test, respectively. The results show that the specific surface area of the composite aerogel is 743 m2/g, the contact angle with water is 146°, and the elastic modulus is 5.1 MPa. After a thermal process in the temperature range from room temperature to 400 ℃, the hydrophobicity remains unchanged (about 138°), and the thermal conductivity of composite aerogel monoliths changes from 0.026 3 W/(m·K) to 0.051 2 W/(m·K). In addition, the mechanisms of solvent exchange and surface modification were also discussed.