Abstract:A large number of studies have been conducted to investigate the pore structure of cement-based materials with the mercury intrusion porosimetry (MIP) method. However, the conventional MIP method has some drawbacks in the measurement of pore size distributions of most porous materials, including cement-based materials. This is mainly because of the lack of direct accessibility of most pore volumes. This paper reports an alternative method to investigate the pore structure with conventional MIP set-up but different testing sequence and different data analysis method. By repeating the intrusion and extrusion cycles in every pressure step, the volume of throat pores and the volume of corresponding ink-bottle pores can be determined at each pore diameter. With the assumption that the size distribution of these ink-bottle pores at each pore diameter is equal to that of the pores larger than the corresponding throat pores, the pore size distribution can be recalculated. The new MIP method is used to investigate the pore structure of Portland cement pastes. The results measured with the new MIP method are compared with those determined with conventional MIP method and backscanning (BSE) image analysis. It is found that the new and conventional MIP measurements give the same total porosity and BSE image analysis gives a relatively lower total porosity. Regardless of the curing age, the result of the new MIP method shows a critial pore diameter smaller than that of the old method and larger than that of the BSE image analysis.

Investigations on pore-structure in cementitious materials using gas intrusion porosimetry

Determining Porosity and Pore Network Connectivity of Cement-Based Materials by a Modified Non-Contact Electrical Resistivity Measurement: Experiment and Theory

Reassessment of mercury intrusion porosimetry for characterizing the pore structure of cement-based porous materials by monitoring the mercury entrapments with X-ray computed tomography

Pore Structure Damages In Cement-Based Materials By Mercury Intrusion: A Non-Destructive Assessment By X-Ray Computed Tomography

A reappraisal of the ink-bottle effect and pore structure of cementitious materials using intrusion-extrusion cyclic mercury porosimetry

Experimental Study on Clay Pore Microstructure Based on SEM and IPP

New mercury porosimetry method for the measurement of pore size distribution in cement-based materials

Tracing Mercury Entrapment in Porous Cement Paste after Mercury Intrusion Test by X-ray Computed Tomography and Implications for Pore Structure Characterization

Empirical Estimation of Pore Size Distribution in Cement, Mortar, and Concrete

Characterization of Pore Structure of Cement-based Materials by Water Vapor Sorption Isotherms

Ink-bottle Effect and Pore Size Distribution of Cementitious Materials Identified by Pressurization–Depressurization Cycling Mercury Intrusion Porosimetry

Pore structure characterization of cement paste by different experimental methods and its influence on permeability evaluation

Pore Structure of Cement Pastes Through NAD and MIP Analysis

Gas Permeability and Electrical Conductivity of Structural Concretes: Impact of Pore Structure and Pore Saturation

Experimental analysis on the relationship between pore structure and capillary water absorption characteristics of cement‐based materials

Analysis of Pore Structure, Contact Angle and Pore Entrapment of Blended Cement Pastes from Mercury Porosimetry Data

Characterizing Pore Structure of Cement Blend Pastes Using Water Vapor Sorption Analysis

EXPERIMENTAL STUDY ON THE CHLORIDE DIFFUSION OF CONCRETE BASED ON ITS PORE STRUCTURE

Assessment on Pore Structure of Western Sichuan Reservoir Through Mercury Intrusion Porosimetry

Pore structure characterization of cement pastes blended with high-volume fly-ash

Visualization of mercury percolation in porous hardened cement paste by means of X-ray computed tomography