Abstract:A digital current‐mode control technology for SIMO dc–dc converter is proposed in this paper to expend the convenience of current‐mode control with different inductor trends. The results show that not only the digital current‐mode controlled SIDO buck converter have a fast load transient response and small cross‐regulation but also the input and output voltages will not affect the stability in the leading edge modulation, which is different from the corresponding analog current‐mode control technology. Summary Current‐mode control is extensively used in dc–dc converters as the merits of fast transient performance, simple control loop, and elimination of right‐half‐plane zeros for boost‐type dc–dc converters. In single‐inductor multiple‐output (SIMO) dc–dc converter, the inductor current would present different trends under different circuit parameters. Therefore, the control logic changes for different inductor current trends, and the corresponding modulations are absolutely different. In this paper, a digital current‐mode control technology for SIMO dc–dc converter is proposed to expend the convenience of current‐mode control with different inductor trends. Choosing continuous conduction mode (CCM) single‐inductor dual‐output (SIDO) dc–dc converter as the research object, the principles are analyzed under different pulse width modulation modes, and the corresponding control algorithms are derived. Moreover, the discrete iterative map model is established to analyze the stability of input and output voltages varying. The results show that not only the digital current‐mode controlled SIDO buck converter has fast load transient response and small cross‐regulation but also the input and output voltages will not affect the stability in the leading edge modulation, which is different from the corresponding analog current‐mode control technology. Finally, the experimental results verify the correctness of the theoretical analysis.

An optimization method for PLL‐based charge control SIMO Buck DC‐DC

A Low Cross Regulation Single-Inductor Multi-Output DCDC Converter

Design of Charge Pump for High-Speed Phase-Locked Loop

A High Swing Charge Pump with Current Mismatch Reduction for PLL Applications

4.3 an 87%-Peak-efficiency DVS-capable Single-Inductor 4-Output DC-DC Buck Converter with Ripple-Based Adaptive Off-Time Control.

An Optimal Peak Current Mode Control Scheme for Critical Conduction Mode (crm) Buck Pfc Converter

Implementation of Close-Loop Control for Interleaved CrM Totem-Pole PFC Converters with GaN Devices

Monolithic Quasi-Sliding-mode Controller for SIDO Buck Converter in PCCM

A Charge-Pump-Based SIMO Buck-Boost DC-DC Converter with Three Operation Modes

A CMOS PLL using current-adjustable charge-pump and on-chip loop filter with initialization circuit

A Layout Optimization Method to Reduce Commutation Inductance of Multi-Chip Power Module Based on Genetic Algorithm

A 96.1% Efficiency Single-Inductor Multiple-Output (SIMO) Buck Converter With 2.1-A/ns Transient Speed and 2.2-A Maximum Current Capacity

A 90% peak efficiency single-inductor dual-output buck-boost converter with extended-PWM control

Modeling and analysis of digital current‐mode controlled single‐inductor dual‐output DC–DC converter with different PWM modulation modes

Deadbeat Control for Single-Inductor Multiple-Output DC–DC Converter With Effectively Reduced Cross Regulation

A Hybrid Pulse Frequency Modulation Control Strategy for L-LLC Resonant Converter

A single-inductor multiple-bipolar-output (SIMBO) converter with fully-adaptive feedback matrix and improved light-load ripple

Quasi-SM Controller for SIDO Buck Converter with Self-Adaptive Free-Wheeling Current Level

A Novel CMOS Charge-Pump Circuit for High-Speed PLL Application

A 0.6V High-Swing Gate-Switching Charge Pump for PLL with Current Self-Matching Technique in 28nm CMOS

Optimization of the SOC-based multi-stage constant current charging strategy using coyote optimization algorithm