Abstract:Improving battery longevity in portable devices usually requires the use of different voltage levels with a wide range of load capability for various functional blocks. Since a single-inductor-multiple-output (SIMO) converter can support multiple output voltages while using only one inductor, it is an excellent candidate to minimize the component count and thus the production cost. However, the cross-regulation and power consumption are two main issues of the previously reported SIMO converters [1-5]. Although pseudo-continuous conduction-mode (PCCM) control with a freewheel period [1] tries to augment power density and eliminate cross-regulation, associated power dissipation of freewheel switch exacerbates its overall efficiency. The charge-control technique with energy recovery presented [2] decouples the output channels between each switching cycle, at the expense of additional switching loss and slow response. The comparator-based controlled SIMO converters are investigated in [3, 4] and the cross-regulation in most channels is improved due to the fast response of the comparator. However, since the channel that is last connected to inductor is inevitably regulated by the accumulative error of all channels to balance the overall inductor current, every load transition at other outputs will introduce serious cross-regulation [3] and load-regulation problem [4] in the channel. In addition, cross-regulation and slow response also limit the application of dynamic voltage scaling (DVS) technique, which is widely used in single-output converters to improve the system power efficiency by providing variable voltage with fast reference tracking.

A Charge-Pump-Based SIMO Buck-Boost DC-DC Converter with Three Operation Modes

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

High voltage PWM/PSM dual-mode asynchronous BUCK converter

PWM/PSM Dual-Mode Controller for High Efficiency DC-DC Buck Converter

A Low Cross Regulation Single-Inductor Multi-Output DCDC Converter

A 96.1% Efficiency Single-Inductor Multiple-Output (SIMO) Buck Converter With 2.1-A/ns Transient Speed and 2.2-A Maximum Current Capacity

A Multi-Modes Charge-Pump Based High Efficiency Wide Input Range DC-DC Converter

4.3 an 87%-Peak-efficiency DVS-capable Single-Inductor 4-Output DC-DC Buck Converter with Ripple-Based Adaptive Off-Time Control.

A Multi-Mode Four-Switch Buck-Boost DC/DC Converter

A 90% peak efficiency single-inductor dual-output buck-boost converter with extended-PWM control

Analysis and Design of Multi-Mode Buck DC/DC Converter

A Single-input Dual-output Three-level Buck Converter for SoC Applications

A CMOS hybrid control mode DC-DC buck converter for embedded system

Four-Switch Buck–Boost Converter Based on Model Predictive Control With Smooth Mode Transition Capability

Multi-mode control strategy in three-level DC-DC converter for higher efficiency operation under light-load and standby conditions

A Monolithic High-Performance Buck Converter with Enhanced Current-Mode Control and Advanced Protection Circuits

Single-Inductor Multiple-Input Multiple-Output Converter With Common Ground, High Scalability, and No Cross-Regulation

Modeling and control of multi-modes charge pump with improved efficiency over wide input and load range

Design And Modeling Of A High Efficiency Step-Up/Step-Down Dc-Dc Converter With Smooth Transition

A high efficiency regulated charge pump over wide input and load range

An optimization method for PLL‐based charge control SIMO Buck DC‐DC