Abstract:Results are presented for modelling of the evaporation and magnetron sputter deposition of Zn(x)O(y) onto an O-terminated ZnO (0001¯) wurtzite surface. Growth was simulated through a combination of molecular dynamics (MD) and an on-the-fly kinetic Monte Carlo (otf-KMC) method, which finds diffusion pathways and barriers without prior knowledge of transitions. We examine the effects of varying experimental parameters, such as substrate bias, distribution of the deposition species and annealing temperature. It was found when comparing evaporation and sputtering growth that the latter process results in a denser and more crystalline structure, due to the higher deposition energy of the arriving species. The evaporation growth also exhibits more stacking faults than the sputtered growth. Post-annealing at 770 K did not allow complete recrystallization, resulting in films which still had stacking faults where monolayers formed in the zinc blende phase, whereas annealing at 920 K enabled the complete recrystallization of some films to the wurtzite structure. At the latter temperature atoms could also sometimes be locked in the zinc blende phase after annealing. When full recrystallization did not take place, both wurtzite and zinc blende phases were seen in the same layer, resulting in a phase boundary. Investigation of the various distributions of deposition species showed that, during evaporation, the best quality film resulted from a stoichiometric distribution where only ZnO clusters were deposited. During sputtering, however, the best quality film resulted from a slightly O rich distribution. Two stoichiometric distributions, one involving mainly ZnO clusters and the other involving mainly single species, showed that the distribution of deposition species makes a huge impact on the grown film. The deposition of predominantly single species causes many more O atoms at the surface to be sputtered or reflected, resulting in an O deficiency of up to 18% in the deposited film and therefore resulting in more stacking faults and phase boundaries. The methods used allow analysis of key mechanisms that occur during the growth process and give hints as to the optimum conditions under which complete crystalline layers can form.

Effect of substrate-tilting angle-dependent grain growth and columnar growth in ZnO film deposited using radio frequency (RF) magnetron sputtering method

Effect of Nucleation and Growth Kinetics on the Electrical and Optical Properties of Undoped ZnO Films

The growth of nanoscale ZnO films by pulsed-spray evaporation chemical vapor deposition and their structural, electric and optical properties

Microstructure and Optical Properties of ZnO Films Deposited by Radio-frequency Reactive Magnetron Sputtering

The Effects of Oxygen Partial Pressure and Substrate Temperature on the Structural and Optical Properties of Zno Films

Deposition and Characterization of AZO Thin Films on Flexible Glass Substrates Using DC Magnetron Sputtering Technique

Influence of O_2/Ar Flow Ratio on Microstructures and Photoluminescence of ZnO Films

Effect of deposition angle on the deposition rate, microstructure, electrical and optical properties of magnetron sputtered ZrB 2 thin films

Crystal Growth of Undoped ZnO Films on Si Substrates under Different Sputtering Conditions

Epitaxial Growth Of Zno On Gan/Sapphire Substrate By Radio-Frequency Magnetron Sputtering

Effect of substrate and substrate temperature on microstructure of magnetron sputtering doped-ZnO thin films

Modelling the growth of ZnO thin films by PVD methods and the effects of post-annealing

Structural evolution of ZnO films deposited by rf magnetron sputtering on glass substrate

Effect of Substrate Temperature and Deposition Power on the Surface Morphology and Optical Properties of ZnO:Mg Thin Films Deposited by DC Magnetron Sputtering

Influence of Sputtering Power on Properties of ZnO Thin Films Fabricated by RF Sputtering in Room Temperature

Deposition Condition Investigation of High c-axis Preferred Orientation ZnO Films Produced by RF Magnetron Sputtering

Deposition and Characterization of Sputtered ZnO Films

Structures and Electric Properties of RF Sputtered ZnO Films

Effects of deposition angle on the thin film quality of indium tin oxide grown by single beam ion source-assisted magnetron sputtering

Effect of the Substrate Temperature on the Property of ZnO Films Deposited by Magnetron Sputtering with DC at the Low Power

Growth of ZnO thin films on LSAT(111) substrates by plasma-assisted radio-frequency molecular beam epitaxy