Copper Oxidation Improves Dodecanethiol Blocking Ability in Area‐Selective Atomic Layer Deposition

Tzu‐Ling Liu,Stacey F. Bent

DOI: https://doi.org/10.1002/admi.202200587

IF: 5.4

2022-06-02

Advanced Materials Interfaces

Abstract:A strategy for achieving better blocking by dodecanethiol (DDT) self‐assembled monolayers (SAMs) for area‐selective atomic layer deposition is demonstrated. The packing of DDT SAMs is improved by partially oxidizing Cu to Cu2O before forming the DDT SAM. In recent years, area‐selective atomic layer deposition (AS‐ALD) has attracted increasing interest for its applications in back‐end interconnect processes, and selective deposition of Al2O3 is of particular interest because Al2O3 can serve as an etch hard mask. However, Al2O3 is one of the most difficult ALD systems to block. In this work, a strategy is presented to enhance the blocking ability of dodecanethiol (DDT) self‐assembled monolayers (SAMs) against Al2O3 ALD. It is shown that by conducting DDT deposition on a slightly oxidized Cu surface, which is mainly composed of Cu2O, rather than on a freshly acid‐etched Cu surface, which mainly consists of metallic Cu, the quality of the DDT SAM can be improved. It is further shown that the DDT SAMs formed on Cu2O‐covered Cu substrates are about 3–4 times more effective in blocking Al2O3 than that on acid‐etched Cu surfaces when ALD is performed under subsaturation condition. However, as the Cu oxidation process continues, CuO is formed and the blocking ability of DDT degrades. Finally, selective Al2O3 deposition on DDT‐treated Cu/low‐k patterns using the combined strategy of Cu oxidation and subsaturation conditions achieves selectivity of 0.99 after 4 nm of Al2O3 ALD.

materials science, multidisciplinary,chemistry