Abstract:Selective catalytic reduction (SCR) technology plays a crucial role in flue gas denitration. The nonuniform distribution of catalyst inlet parameters causes the nonuniform distribution of NO concentration at the outlet, thus affecting accuracy of ammonia injection. Regarding this issue, this paper describes the impacts of nonuniform velocity and temperature on both the confidence of NO concentration measured at a single measuring point at the outlet and the denitration efficiency, which can provide a basis for structural optimization of SCR denitration reactor and decrease in ammonia slip. The random distribution form of velocity and temperature above the catalyst layer are derived from the actual gas volume and the actual SCR reactor model, and then the catalyst inlet boundary conditions were generated with different relative standard deviation of velocity and temperature accordingly. The confidence of outlet NO concentration measurement results can be counted by means of Monte Carlo simulation. Finally, the relation model can be obtained to calculate the confidence of outlet NO concentration measurement results at different working conditions. The results show that within the gas volume range of this work, in order to ensure the confidence of the NO concentration measurement results, the relative standard deviation of temperature before the catalyst inlet must be within 0.005 and the relative standard deviation of velocity before the catalyst inlet must be within 0.1. With the increase in relative standard difference in temperature, there is a slight decrease in the efficiency of denitration. With the different mean value of temperature, the variation range of denitration efficiency is similar to that of temperature-relative standard difference. With the different mean value of velocity, the deviation range of corresponding efficiency is similar to that of the temperature-relative standard difference. When the relative standard difference in velocity increases, the denitration efficiency decreases slightly. The greater velocity value, the decreasing range of denitration efficiency is larger than the variation range of relative standard difference in velocity.

Effect of Catalyst Inlet Flow Field Distribution Characteristics on Outlet NO Concentration Distribution in SCR Denitration Reactor Based on Monte Carlo Method

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Influence of Non-uniform Distributions of Inlet Velocity and Reductant on SCR DeNOx Performance

CFD analysis of influencing factors on SCR denitration efficiency of sintering flue gas based on response surface methodology

Numerical Simulation of SCR of NOx with NH 3

Numerical Simulation of SCR of NOx with NH3 on Fe-based Catalyst

Numerical simulation of inner abrasion in a selective catalytic reduction deNOx device

Optimal Design of Selective Catalyst Reduction Denitrification System Using Numerical Simulation.

Precise ammonia injection strategy in SCR denitrification system based on non-uniform inlet parameters

Modeling the Effect of Nonuniformities from Urea Injection on SCR Performance Using CFD

Velocity Distribution Measuring Method Used in a Power Station Selective Catalytic Reduction System

Optimal design of a SCR-DeNOx system for a 300MW coal-fired power plant

Experimental and Numerical Simulation of Catalyst Deactivation Caused by Transient Turbulence in Gradient Flow Field

Influence of Urea-SCR System Parameters on NOx Conversion Rate and Liquid Film

Experimental study on selective catalytic reduction failure of low NH3-NOx ratio

Optimization Analysis of Various Parameters Based on Response Surface Methodology for Enhancing NOx Catalytic Reduction Performance of Urea Selective Catalytic Reduction on Cu-ZSM-13 Catalyst

Numerical Simulation and Optimization of Flow Field in the SCR Denitrification System on a 600 MW Capacity Units

Ammonia injection method for SCR based on non-uniform inlet condition

Investigating the Optimization Design of Internal Flow Fields Using a Selective Catalytic Reduction Device and Computational Fluid Dynamics