Abstract:Selective catalytic reduction (SCR) technology plays a crucial role in flue gas denitration. The nonuniform distribution of catalyst inlet parameters causes the nonuniform distribution of NO concentration at the outlet, thus affecting accuracy of ammonia injection. Regarding this issue, this paper describes the impacts of nonuniform velocity and temperature on both the confidence of NO concentration measured at a single measuring point at the outlet and the denitration efficiency, which can provide a basis for structural optimization of SCR denitration reactor and decrease in ammonia slip. The random distribution form of velocity and temperature above the catalyst layer are derived from the actual gas volume and the actual SCR reactor model, and then the catalyst inlet boundary conditions were generated with different relative standard deviation of velocity and temperature accordingly. The confidence of outlet NO concentration measurement results can be counted by means of Monte Carlo simulation. Finally, the relation model can be obtained to calculate the confidence of outlet NO concentration measurement results at different working conditions. The results show that within the gas volume range of this work, in order to ensure the confidence of the NO concentration measurement results, the relative standard deviation of temperature before the catalyst inlet must be within 0.005 and the relative standard deviation of velocity before the catalyst inlet must be within 0.1. With the increase in relative standard difference in temperature, there is a slight decrease in the efficiency of denitration. With the different mean value of temperature, the variation range of denitration efficiency is similar to that of temperature-relative standard difference. With the different mean value of velocity, the deviation range of corresponding efficiency is similar to that of the temperature-relative standard difference. When the relative standard difference in velocity increases, the denitration efficiency decreases slightly. The greater velocity value, the decreasing range of denitration efficiency is larger than the variation range of relative standard difference in velocity.

Modeling the Effect of Nonuniformities from Urea Injection on SCR Performance Using CFD

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Robust, Model-Based Urea Dosing Control for SCR Aftertreatment Systems using a Cross-Sensitive Tailpipe NOx Sensor

Influence of Urea-SCR System Parameters on NOx Conversion Rate and Liquid Film

Estimation of Ammonia Storage Nonuniformity for Urea-Based Selective Catalytic Reduction Systems

Ammonia injection method for SCR based on non-uniform inlet condition

Urea Injection and Uniformity of Ammonia Distribution in SCR System of Diesel Engine

Influence of Non-uniform Distributions of Inlet Velocity and Reductant on SCR DeNOx Performance

Experimental investigation of urea injection strategy for close-coupled SCR aftertreatment system to meet ultra-low NO<i><sub>x</sub></i> emission regulation

Experiment and Simulation of Ammonia Distribution Uniformity for Diesel Engine Urea-SCR

Effects of key operating parameters on SCR performance of diesel engines

Numerical analysis of ammonia homogenization for selective catalytic reduction application

CFD-based investigation of NO x removal from industrial waste gas by selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR) process using NH 3

Effect of Catalyst Inlet Flow Field Distribution Characteristics on Outlet NO Concentration Distribution in SCR Denitration Reactor Based on Monte Carlo Method

Coupling of Liquid and Surface Chemistry in Urea SCR Systems

Optimization Analysis of Various Parameters Based on Response Surface Methodology for Enhancing NOx Catalytic Reduction Performance of Urea Selective Catalytic Reduction on Cu-ZSM-13 Catalyst

Numerical Simulation to Reduce NOx of Diesel Engine Urea-SCR System

3D Modeling of Flow, Spray of Reductant and Surface Chemical Reaction in Diesel Urea SCR-NOx Catalytic Converter

Tuning the Standard SCR Reaction Kinetics to Model NO Conversion in a Diesel Engine Exhaust SCR Catalyst System Under Steady State Conditions in 1D and 3D Geometries Using Ammonia Gas as the Reductant

Experimental study on selective catalytic reduction failure of low NH3-NOx ratio

Research on SCR Urea Injection Method of Diesel Engine