Abstract:To respond the China’s “14th Five-Year Plan” on the control of nitrogen oxides (NOX) emission, urea-based selective catalytic reduction (SCR) system has been widely applied to reduce the NOX emission from the diesel engine. NO2 is no longer a factor to be ignored while refining the SCR-DeNOX system model because of the ship diesel engine's long-term low temperature and oxygen-rich condition, which provides abundant conditions for the creation of NO2. Therefore, a refined eight-state two-cell SCR-DeNOX model is established in this paper. Meanwhile, the trade-off between NOX emission and tailpipe ammonia (NH3) slip is one of the major challenges which SCR-DeNOX system is facing. While meeting NOX emission standards, the requirement of limiting NH3 slip to prevent secondary pollution is becoming increasingly urgent, which needs a better structure or controller. Therefore, a two-cell SCR-DeNOX system with a by-pass valve in front of the NH3 injection is designed, integral sliding mode control based on inversion algorithm (IA_ISMC) is proposed for each cell. Based on the FTP-75 test cycle, there are three points of view are presented. Firstly, compared with the traditional six-state model, simulation results from the refined eight-state SCR-DeNOX model are closer to the experimental data. Secondly, the introduction of the by-pass structure has a mild impact on the NOX conversion efficiency, but can largely limit the NH3 slip. Finally, the controller based on IA_ISMC effectively improves the tracking performance of NH3 coverage ratio and reduces the cost of NH3 injection. To sum up, the refined two-cell SCR-DeNOX system with a by-pass valve based on IA_ISMC can enhance SCR performance and lower costs.

Estimation of Ammonia Storage Nonuniformity for Urea-Based Selective Catalytic Reduction Systems

Robust, Model-Based Urea Dosing Control for SCR Aftertreatment Systems using a Cross-Sensitive Tailpipe NOx Sensor

Robust Nonlinear Disturbance Observer Design for Estimation of Ammonia Storage Ratio in Selective Catalytic Reduction Systems

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Experiment and Simulation of Ammonia Distribution Uniformity for Diesel Engine Urea-SCR

Model-based NH3 Adaptation Method for SCR Control

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Modeling the Effect of Nonuniformities from Urea Injection on SCR Performance Using CFD

Ammonia injection method for SCR based on non-uniform inlet condition

Ammonia storage and slip under steady and transient state in close-coupled SCR

Simulation Study of Ammonia Storage Characteristics of Selective Catalytic Reduction for Diesel Engines

Influence of Urea-SCR System Parameters on NOx Conversion Rate and Liquid Film

Influence of Non-uniform Distributions of Inlet Velocity and Reductant on SCR DeNOx Performance

Experimental study on selective catalytic reduction failure of low NH3-NOx ratio

Selective Catalytic Reduction Failure of Low NH3-NOx Ratio

Urea Injection and Uniformity of Ammonia Distribution in SCR System of Diesel Engine

A Technical Method to Improve NOx/NH3 Mixing Ratio in SCR System and Its Engineering Applications

An intelligent control of NH3 injection for optimizing the NOx/NH3 ratio in SCR system

Experimental Research on Aftertreatment SCR Sizing Strategy for a Nonroad Mid–Range Diesel Engine

Application of NMPC on optimization of ammonia coverage ratio references in two-can diesel SCR systems

Experimental investigation on the characteristics of ammonia storage for heavy-duty diesel engine SCR catalyst