Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

An auxiliary thermal stress forming method for realizing large angle

Experimental Study of High-Frequency Vibration Assisted Micro/Mesoscale Forming of Metallic Materials

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Design of an innovative laser-assisted four-point bending forming process for high-stiffened structure of aluminum alloy

Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Research on the Mechanism and Processability of Roll Forming

Research on Bending Angels of Laser Peen Forming Without Confine Layer

Artificial thermal strain method: A novel approach for the analysis and fast prediction of the thermal distortion

Experimental and numerical investigation on laser beam forming of steel sheets

The saturated convex bending curvature of 7075 aluminum panel bent by orthogonal laser shock forming

An improved fused deposition modeling process for forming large-size thin-walled parts

Process and Development of Laser Forming

Influence of bending angle function on local thinning defects of roll-formed sheets based on segmental boundary combination optimization

Investigation of the Bending Process and Theory in Free-Boundary Pneumatic Film-Forming for Curved Image Sensors

Study on Thermodynamic Behavior, Microstructure and Mechanical Properties of Thin-Walled Parts by Selective Laser Melting

Process parameters optimization of differential heating push-bending for small bending radius tube based on orthogonal experiments

An extended mesoscaled M-K model for predicting discrete ultimate strains and evaluating the effect of normal stress on forming limits

Research on warm laser shock sheet micro-forging