Abstract:Braiding is an attractive manufacturing method for tubular elements such as hollow shafts and struts. One of the main challenges however is the integration of suitably performing end-fittings. Recent advances in additive layer manufacture have enabled the fabrication of end-fittings which can be ‘co-impregnated’ or ‘co-cured’ with the fibre preform in a single step, i.e. without the need for secondary adhesive bonding. This requires the introduction of protrusions onto the surface of the end-fitting to promote mechanical interlocking with the fibres. However, the lack of accurate modelling tools for the simulation of this manufacturing process means that much empiricism is currently used in the design of such structures. A novel numerical framework is presented here for the full-scale simulation of the braiding process over structured end-fittings. Nonlinear finite element analysis is applied at the meso-scale, with strands of beam elements representing individual yarns and meshed surfaces modelling the mandrel and tooling. Penalty-based contact formulations are then used to simulate all inter-yarn and yarn-metal interactions, enabling detailed predictions of fibre paths around surface protrusions. In order to verify and validate this numerical framework, a series of full-scale braiding experiments was conducted using additively-manufactured thermoplastic mandrels. Final braid patterns as well as the occurrence of braid imperfections were investigated and compared to model predictions. It is shown that the proposed modelling strategy reproduces well the trends observed experimentally in terms of final braid quality. A parametric study was then conducted on the effects of initial end-fitting alignment with respect to oncoming yarns, suggesting that better control over this parameter could reduce considerably the occurrence of braid imperfections.

Development of the Technology of Manufacturing Aerospace Composite Tubular Elements by Radial Braiding

Manufacture of Aerospace Lattice Structures by Radial Braiding

Shape Memory Polymer S-shaped Mandrel for Composite Air Duct Manufacturing

Design Method for Braiding Process and Structure Parameters of Three Dimensional Two-Step Tubular Braided Preform

Spatial distribution of yarns and mechanical properties in 3D braided tubular composites

Finite element analysis of 2-D tubular braided composite based on geometrical models to study mechanical performances

Integrated Design For Manufacturing of Braided Preforms For Advanced Composites Part II: 3D Braiding

Structural mechanics of 3-D braided preforms for composites. IV - The 4-step tubular braiding

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Experimental and numerical studies on the braiding of carbon fibres over structured end-fittings for the design and manufacture of high performance hybrid shafts

Research Status of 3D Braiding Technology

Theoretical analysis of braiding strand trajectories and simulation of three-dimensional parametric geometrical models for multilayer interlock three-dimensional tubular braided preforms

Research on effects of braiding process on the composite preform quality using finite element method

Automation of the technology of connecting parts in the manufacture of aerospace products

Development of equipment for composite 3D printing of structural elements for aerospace applications

RADIAL EXTRUSION OF A PIPE BILLET WITH INTERNAL LEDGE. METHODS FOR CALCULATING THE TECHNOLOGICAL PARAMETERS OF EXTRUSION OF PRODUCTS WITH THE SAME RADII OF THE UPPER AND LOWER PARTS

Thermal stress distribution of multi-layered composite tubes affected by braiding angle

Development of a generalized analytical model for tubular braided-architecture composites

Track design and realization of braiding for three-dimensional variably shaped cross-section preforms

Development and Manufacturing of a Fibre Reinforced Thermoplastic Composite Spar Produced by Oven Vacuum Bagging

Analysis of Thermomechanical Behavior of the Tubular Braided Fabrics with Flax/Polyamide Commingled Yarns