Abstract:Braiding is an attractive manufacturing method for tubular elements such as hollow shafts and struts. One of the main challenges however is the integration of suitably performing end-fittings. Recent advances in additive layer manufacture have enabled the fabrication of end-fittings which can be ‘co-impregnated’ or ‘co-cured’ with the fibre preform in a single step, i.e. without the need for secondary adhesive bonding. This requires the introduction of protrusions onto the surface of the end-fitting to promote mechanical interlocking with the fibres. However, the lack of accurate modelling tools for the simulation of this manufacturing process means that much empiricism is currently used in the design of such structures. A novel numerical framework is presented here for the full-scale simulation of the braiding process over structured end-fittings. Nonlinear finite element analysis is applied at the meso-scale, with strands of beam elements representing individual yarns and meshed surfaces modelling the mandrel and tooling. Penalty-based contact formulations are then used to simulate all inter-yarn and yarn-metal interactions, enabling detailed predictions of fibre paths around surface protrusions. In order to verify and validate this numerical framework, a series of full-scale braiding experiments was conducted using additively-manufactured thermoplastic mandrels. Final braid patterns as well as the occurrence of braid imperfections were investigated and compared to model predictions. It is shown that the proposed modelling strategy reproduces well the trends observed experimentally in terms of final braid quality. A parametric study was then conducted on the effects of initial end-fitting alignment with respect to oncoming yarns, suggesting that better control over this parameter could reduce considerably the occurrence of braid imperfections.

Research on effects of braiding process on the composite preform quality using finite element method

Design and analysis of the mandrel structure for a composite S-shaped inlet

Spatial distribution of yarns and mechanical properties in 3D braided tubular composites

Experimental and numerical studies on the braiding of carbon fibres over structured end-fittings for the design and manufacture of high performance hybrid shafts

Integrated Design For Manufacturing of Braided Preforms For Advanced Composites Part II: 3D Braiding

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates

Theoretical analysis of braiding strand trajectories and simulation of three-dimensional parametric geometrical models for multilayer interlock three-dimensional tubular braided preforms

Non-Axisymmetric Overbraiding Process Modeling Based on Enhanced Kinematic Models

Design Method for Braiding Process and Structure Parameters of Three Dimensional Two-Step Tubular Braided Preform

A Methodology to Obtain the Accurate RVEs by a Multiscale Numerical Simulation of the 3D Braiding Process

Research Status of 3D Braiding Technology

Finite Element Modeling of Mechanical Properties of 3D Five-Directional Rectangular Braided Composites

Simulation analysis of parametric effects on consolidation ofangle bended composites

A novel numerical simulation method for predicting compressive properties of 3D multiaxial braided composites considering various defects

A review of the formability of woven fabrics for composite materials

Multi-scale modeling and elastic properties prediction of 3D four-directional tubular braided composites

Structure Design on Thermoplastic Composites Considering Forming Effects

Nonlinear Mechanical Property of 3D Braided Composites with Multi-Types Micro-Distortion: A Quantitative Evaluation

Track design and realization of braiding for three-dimensional variably shaped cross-section preforms

Study on in-plane compression properties and numerical modeling of three dimensional five-directional braided composites

Research Progress in Numerical Simulation of Fiber Reinforced Thermosetting Resin Matrix Composites Molding Process