Abstract:Braiding is an attractive manufacturing method for tubular elements such as hollow shafts and struts. One of the main challenges however is the integration of suitably performing end-fittings. Recent advances in additive layer manufacture have enabled the fabrication of end-fittings which can be ‘co-impregnated’ or ‘co-cured’ with the fibre preform in a single step, i.e. without the need for secondary adhesive bonding. This requires the introduction of protrusions onto the surface of the end-fitting to promote mechanical interlocking with the fibres. However, the lack of accurate modelling tools for the simulation of this manufacturing process means that much empiricism is currently used in the design of such structures. A novel numerical framework is presented here for the full-scale simulation of the braiding process over structured end-fittings. Nonlinear finite element analysis is applied at the meso-scale, with strands of beam elements representing individual yarns and meshed surfaces modelling the mandrel and tooling. Penalty-based contact formulations are then used to simulate all inter-yarn and yarn-metal interactions, enabling detailed predictions of fibre paths around surface protrusions. In order to verify and validate this numerical framework, a series of full-scale braiding experiments was conducted using additively-manufactured thermoplastic mandrels. Final braid patterns as well as the occurrence of braid imperfections were investigated and compared to model predictions. It is shown that the proposed modelling strategy reproduces well the trends observed experimentally in terms of final braid quality. A parametric study was then conducted on the effects of initial end-fitting alignment with respect to oncoming yarns, suggesting that better control over this parameter could reduce considerably the occurrence of braid imperfections.

Design Method for Braiding Process and Structure Parameters of Three Dimensional Two-Step Tubular Braided Preform

Structural mechanics of 3-D braided preforms for composites. IV - The 4-step tubular braiding

Spatial distribution of yarns and mechanical properties in 3D braided tubular composites

Integrated Design For Manufacturing of Braided Preforms For Advanced Composites Part II: 3D Braiding

On the topological yarn structure of 3-D rectangular and tubular braided preforms

Track design and realization of braiding for three-dimensional variably shaped cross-section preforms

Theoretical analysis of braiding strand trajectories and simulation of three-dimensional parametric geometrical models for multilayer interlock three-dimensional tubular braided preforms

Three-dimensional Braiding Machine with Variable Braiding Pattern

Research Status of 3D Braiding Technology

Topology-based parametric modeling of three-dimensional hexagonal braids for advanced composite structures

Experimental and numerical studies on the braiding of carbon fibres over structured end-fittings for the design and manufacture of high performance hybrid shafts

Multi-scale modeling and elastic properties prediction of 3D four-directional tubular braided composites

Research on effects of braiding process on the composite preform quality using finite element method

A STRUCTURAL ANALYSIS OF THREE-DIMENSIONAL BRAIDS

Thermal stress distribution of multi-layered composite tubes affected by braiding angle

The formation mechanism of gradient properties and the regulation mechanism of elastic properties in three‐dimensional tubular braided composites

Unit-cell geometry and mechanical properties of three-dimensional seven-directional braided composites

Parametric characteristics analysis of three cells in 3D and five-directional annular braided composites

Finite element analysis of 2-D tubular braided composite based on geometrical models to study mechanical performances

Development of a generalized analytical model for tubular braided-architecture composites

Three-point Bending Behavior and Energy Absorption Capacity of Composite Tube Reinforced by Gradient Braided Structure in Radial Direction