Abstract:The transformation-assisted consolidation under pressure has been demonstrated to be a promising method to fabricate the nano or submicron polycrystalline ceramic materials. The high pressure suppresses the long-range diffusion of the atoms and, consequently, restrains the grain coarsening. The new phases produced at high pressure could show finer grains under the appropriate thermodynamic conditions, which are not subject to the grain size of the raw materials. Ceramic materials exhibit the existence of the transformations under certain thermodynamic conditions and the formation of new phases generally undergoes the nucleation and growth. In the present work, monoclinic microcrystal ZrO2 with average grain size of 2 µm and Y2O3 with average grain size of 50 nm were mixed in molar ratio of 97∶3. The preparation of the samples was carried out by sintering at 5.5 GPa and temperatures of 800–1700 °C using the high pressure cubic cell, and the sample characterization was performed via the X-ray diffraction, scanning electron microscope and transmission electron microscopy. It was found that the monoclinic and submicron tetragonal composite polycrystalline ZrO2 in bulk is obtained under high pressure and high temperature. The average grain size of tetragonal ZrO2 fabricated at 1200, 1400, 1600 and 1700 °C is (145±62) nm, (246±165) nm, (183±62) nm and (245±107) nm, respectively. The synthesis of the fine-grained polycrystalline materials by the transformation under high pressure can solve the problems of agglomeration, adsorption and grain coarsening caused by the nanopowders as the starting materials in the conventional approach, which would be an alternative route to fabricate the fine-grained polycrystalline materials with the enhanced performances.

Phase Transformations in the Surface Layer of Compact Zirconium Nitride-Based Ceramics

Fabrication of Submicron Tetragonal Polycrystalline ZrO2 by the Transformation of Micro Monoclinic ZrO2 under High Pressure

Oxygen vacancy mediated cubic phase stabilization at room temperature in pure nano-crystalline Zirconia films: A combined experimental and first-principles based investigation

A quantitative microscopic view on the gas‐phase‐dependent phase transformation from tetragonal to monoclinic ZrO2

Microstructure evolution and mechanism during nitridation of carbon-containing internal gelation-derived zirconia

Research on the Existence and Stability of Interfacial Tetragonal Zirconia Formed on Zirconium Alloys

MULTILAYER TUNGSTEN/QUASI-CRYSTAL Ti-Zr-Ni SYSTEMS AS PROMISING MATERIALS OF PROTECTIVE ELEMENTS A FUSION REACTOR

Martensitic transformation in zirconia. Part I: nanometer scale prediction and measurement of transformation induced relief

Synthesis and Characterization of Zirconium Nitride Nanopowders by Internal Gelation and Carbothermic Nitridation

From design to characterization of zirconium nitride/silicon nitride nanocomposites

Structural and Phase Transformations in Plasma-Spray ZrB2–SiC–AlN Coatings on a C/C–SiC Substrate After High-Temperature Thermal Cyclic Heating

Atomic force microscopy study of the tetragonal to monoclinic transformation behaviour of silica doped yttria-stabilized zirconia

Phase Transformation Temperatures and Solute Redistribution in a Quaternary Zirconium Alloy

Regularities of Changes in the Structure of Different Phases of Deformed Zirconium Alloys as a Result of Raising the Annealing Temperature According to Texture Analysis Data

Surface analysis of Zircaloy-2 implanted with carbon before and after oxidation in air at 500 °C

Investigation into the Change of Structure, Mechanical Properties and Thermal Stability for ZrN Coating by Oxygen Addition

Thickness Dependence of the Crystallization and Phase Transition in ZrO 2 Thin Films

Size-driven phase transformation and microstructure evolution of ZrO2 nanocrystallites associated with thermal treatments

Characterizing the ZrC(111)/c-ZrO2(111) Hetero-Ceramic Interface: First Principles DFT and Atomistic Thermodynamic Modeling

The Role of Oxygen Vacancies in Phase Transition and the Optical Absorption Properties within Nanocrystalline ZrO2

Influence of Protection Layers on Thermal Stability of Nitride Thin Films