Abstract:The results of a study on the development and testing of a heat-resistant coating in a Si-TiSi2-MoSi2-TiB2-CaSi2 system to protect Cf/C-SiC composites from oxidation and erosional entrainment in high-speed flows are presented here. The coating was formed using firing fusion technology on the powder composition. Oxidation resistance tests were carried out under static conditions in air at 1650 °C and under conditions of interaction with high-speed air plasma flows, with Mach numbers M = 5.5-6.0 and enthalpy 40-50 MJ/kg. The effectiveness of the protective action of the coating was confirmed at surface temperatures of Tw = 1810-1820 °C for at least 920-930 s, at Tw = 1850-1860 °C for not less than 510-520 s, at Tw = 1900-1920 °C for not less than 280-290 s, and at Tw = 1940-1960 °C for not less than 100-110 s. The values of the rate of loss of the coating mass and the rate constant of heterogeneous recombination of atoms and ions of air plasma on its surface were estimated. The performance of the coating was ensured by the structural-phase state of its main layer, and the formation and evolution on its surface during operation of a passivating heterogeneous oxide film. This film, in turn, is composed of borosilicate glass with titanium and calcium liquation inhomogeneities, reinforcing TiO2 microneedles and in situ Si2ON2 fibers. It was shown that at Tw ≥ 1850-1860 °C, the generation of volatile silicon monoxide was observed at the "oxide layer-coating" interface, followed by the effects of boiling and breakdown degradation of the oxide film, which significantly reduced the lifespan of the protective action of the coating.

Structural and Phase Transformations in Plasma-Spray ZrB2–SiC–AlN Coatings on a C/C–SiC Substrate After High-Temperature Thermal Cyclic Heating

The Microstructure of Al2O3/TiO2-NiCrBSi Graded Thermal Barrier Coatings Produced by Flame Spraying

The Oxidation Behavior of ZrB2-SiC Ceramic Composites Fabricated by Plasma Spray Process

Synthesis of In Situ ZrB2-SiC-ZrC Coating on ZrC-SiC Substrate by Reactive Plasma Spraying

Oxidation Resistance of a Si-TiSi2-MoSi2-TiB2-CaSi2 Coating on a Cf/C-SiC Substrate in High-Speed High-Enthalpy Air Plasma Flows

High temperature oxidation resistance of Y2O3 modified ZrB2-SiC coating for carbon/carbon composites

Oxidation ablation resistance of ZrB2-HfB2-SiC-TaSi2 coating prepared on C/C composite surface

Phase and microstructure evolutions of in-situ ZrC composite coating under plasma torch ablation

High Temperature Oxidation and Oxyacetylene Ablation Properties of ZrB2-ZrC-SiC Ultra-High Temperature Composite Ceramic Coatings Deposited on C/C Composites by Laser Cladding

Structure and Properties of Thermal Barrier Coating Prepared by Alumina Coated Zirconia Composite Powder

Electrochemical Corrosion of Composite Ceramics and Thermal Spray Coatings in the ZrB2–SiC–AlN System

Multi-cycle and long-term ablation behavior of Cf/ZrB2-SiC composites at 2500 °C

Effect of temperature-dependent nano SiC on the ablation resistance of ZrC coating

A novel plasma-sprayed Cr/FeCrAl dual-layer coating on Zr alloy for potential high‐temperature applications

Anti-ablation Performance of Plasma Sprayed ZrB2/SiC Coatings on C/C Substrates and the Influence of a Chemical Vapor Deposited SiC Interlayer

High-temperature performance of thermal environmental barrier coatings in 90%H2O-10%O2 conditions at 1475 °C

The high-temperature oxidation and mechanical properties of the Cr/Zr and CrN/Zr coating

Microstructure and thermal behaviour of plasma sprayed zirconia/alumina composite coating

High-Temperature Oxidation And Tensile Behaviors Of Cral Coating On Zirconium Alloy

Microstructure and Ablation Behavior of W/ZrC/SiC Coating on C/C Composites Prepared by Reactive Melt Infiltration and Atmospheric Plasma Spraying

RETRACTED ARTICLE: Ablation Behavior of SiC/ZrB2 Multilayer Coating Prepared by Plasma Spray Method