Abstract:Non-conventional collectors where organic fluid or refrigerant experience a phase change have many advantages over conventional collectors which have either air or relatively high temperature boiling liquid. Increase in heat transfer coefficient and system efficiency, corrosion prevention and freeze protection are the main benefits of the first type. In this study, a detailed numerical model of a flat plate collector is developed to investigate the fluid mean temperature, useful heat gain and heat transfer coefficient along the collector tube. The refrigerant HFC-134a was used in the simulation as the working fluid of the collector. The model can both predict the location where the fluid undergoes a phase change in the tube and the state at the exit under given inlet conditions. The effect of boiling on the heat transfer coefficient of the fluid is also investigated. Simulations were performed at three different mass flow rates (0.001, 0.005 and 0.01 kg/s) and three different operating pressures (4, 6 and 8 bar) to be able to see the effect of mass flow rate and pressure on plate temperature, heat loss coefficient, efficiency of the collector and the heat transfer coefficient of the fluid. The simulation results indicate that the heat transfer coefficient of the fluid increases from 153.54 W/m(2) K to 610.27 W/m(2) K in multiphase flow region. In the liquid single phase region, the collector efficiency rises from 60.2% to 68.8% and the heat transfer coefficient of the fluid increases from 39.24 W/m(2) K to 392.31 W/m(2) K with an increased flow rate whereas the collector efficiency decreases from 72.5% to 62.3% as the operating pressure increases from 4 bar to 8 bar. In order to validate the simulation model an experimental test rig was built and the experiments were performed with HFE 7000 as working thermo-fluid. A new simulation model utilizing HFE 7000 has been developed and the outlet temperature of the fluid was compared with the measured outlet temperature. Both measured and simulated results have shown close conformity. (C) 2015 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/).

Numerical and experimental study of thermal efficiency of a spiral flat plate solar collector by changing the spiral diameter, flow rate, and pipe diameter

Energy and exergy analysis of conventional and modified flat-plate solar collector with dual spiral flow tubes: A comparative study

Numerical and experimental analysis of the flat plate solar water heater systems' thermal performance

Experimental performance enhancement of a flat plate solar collector using straight and twisted flow inserts

Experimentally validated axisymmetric simulation for thermo-fluid performance of an active flat-plate solar water heater at low flow rates

Turbulent flow-thermal-thermodynamic characteristics of a solar air heater with spiral fins

Numerical Study to Investigate the Performance of U-shaped Flat Plate Solar Collector Using Phase Change Materials (PCMs)

Thermal analysis of a flat-plate solar collector filled with water under the dynamic operation via a multiparameter sensitivity analysis utilizing the Monte-Carlo method

Investigation of the enhancement of heat transfer in a flat plate solar collector with a corrugated tube under thermosiphon effect

Thermal Performance Analysis of Porous Foam-Assisted Flat-Plate Solar Collectors with Nanofluids

Experimental and numerical study to develop TRANSYS model for an active flat plate solar collector with an internally serpentine tube receiver

Numerical Performance Investigation of Parabolic Dish Solar-Assisted Cogeneration Plant Using Different Heat Transfer Fluids

Sustainable and renewable energy management by investigating the effect of the diameter of finned tubes of a solar collector on its heat production in the presence of phase change materials in a residential building

CFD-thermal analysis of flat plate solar collector for different temperature variations

CFD Analysis of Heat Transfer Enhancement in a Flat-Plate Solar Collector/Evaporator with Different Geometric Variations in the Cross Section

Numerical Simulation of the Thermal Performance of a Tubular Solar Air Heater

Numerical simulation of an innovative design of solar air heater using spiral duct inserts for enhancing thermal efficiency

Numerical simulation of the performance of a novel parabolic solar receiver filled with nanofluid

Mathematical Modelling and Simulation of Multiphase Flow in a Flat Plate Solar Energy Collector

Research of Flat Heat Pipe Solar Collector Device

Thermal Performance of a Flat-Plate Solar Collector for Drying Agricultural Crops