Abstract:This paper presents the design and test results for a dual-lane fault-tolerant PM motor for a safety critical aircraft actuator. Motor topology has been chosen to meet the system availability and reliability criterion considering principal faults that can occur within the motor including winding open circuit, line to line and phase to ground short circuits. The motor has two 3-phase windings which are powered from two independent inverters connected to different power supplies. The motor control strategy employs a healthy winding channel to have the capability to drive the load with the other winding channel short circuited in a faulted condition. The windings are designed to have a high impedance to limit the short circuit current to 1 p.u. A rectangular winding conductor is chosen to achieve a higher slot fill factor and for better manufacturability, which would also minimise the probability of turn to turn faults due to its thicker insulation. The effect of lateral magnetic pull has been considered to determine the locations of the dual-lane windings. Performance has been predicted by finite element analysis in healthy and faulted conditions. A prototype machine has been built and tested. Test results agree with the analysis in healthy and most of faulted conditions. However, measured drag torque with shorted windings is greater than the prediction at higher speeds, which is thought to be the effect of eddy currents in the conductors and magnets. It has confirmed that the induced current in a shorted turn is greatly affected by its location and the induced current may not be limited to 1 p.u. by short circuiting the machine phase terminals.

Design and test results for dual-lane fault-tolerant PM motor for safety critical aircraft actuator

Fault-Tolerant Operation for Single-Phase Open Circuit of Dual-Armature Flux-Switching Permanent Magnet Machine by Connecting Neutral Points

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

A Novel Dual Permanent Magnet Fault-Tolerant Vernier Machine with Hybrid Stator Configuration

Fault-Tolerance Performance Analysis of a Five-Phase Permanent-Magnet Linear Synchronous Machine

A 5-Phase Fault-Tolerant Brushless Permanent Magnet Motor Drive for an Aircraft Thin Wing Surface Actuator

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

A Dual-Winding Fault-Tolerant Motor Drive System Based on the Redundancy Bridge Arm

Design and Control of a Novel Fault-tolerant Dual-armature Winding Flux Modulated Permanent Magnet Machine

Multiphase Power Converter Drive for Fault-Tolerant Machine Development in Aerospace Applications

A Comparative Study on Two Outer Rotor PMSMs for In-Wheel Direct Drive under Short-Circuit Faults

Design and Analysis of a New Fault-Tolerant Magnetic-Geared Permanent-Magnet Motor

Development of a Fault-Tolerant Permanent-Magnet Synchronous Motor

Design and Testing of a Four-Phase Fault-Tolerant Permanent-Magnet Machine for an Engine Fuel Pump

Twofold Fail-Work Remedy for Reconfigurable Driver and Windings of Four-Phase Permanent Magnet Fault-Tolerant Motor System

Fault Analysis for Inverter Driven Dual-Winding PMSMs

Fault tolerant control of dual-rotor PMSM under open-circuit fault conditions

Operating Principle and Performance Analysis of a Novel Stator-PM Fault Tolerant Machine

Robust Control of Fault-Tolerant Permanent-Magnet Synchronous Motor for Aerospace Application With Guaranteed Fault Switch Process

Design and Analysis of a Five-Phase Permanent-Magnet Synchronous Motor for Fault-Tolerant Drive

Two short-circuit fault tolerant strategies for four-phase permanent-magnet fault-tolerant machine