Abstract:The five‐phase six‐leg inverter is adopted for the fault‐tolerant control of the five‐phase PMSM, which can relieve the constraint of the zero neutral point current and improve the performance of the machine. The maximum torqu MT and MC current regulations are considered under different open‐circuit conditions, and their effectiveness are verified by the experiments. Five‐phase permanent magnet synchronous machine (PMSM) can operate under open‐circuit faults with the appropriate current regulations. However, the traditional current regulations based on the five‐phase half‐bridge inverter have to satisfy the constraint of zero neutral point current, which limits the fault‐tolerant performance of the machine. Thus, this paper investigates the current regulation based on the five‐phase six‐leg (FPSL) inverter, which relieves the zero‐neutral point current limitation, and both current regulations considering the maximum torque (MT) and minimum copper loss (MC) are derived under different open‐circuit conditions. The cost of the system has increased, but with the new regulations, better fault‐tolerant operation capability of the machine can be obtained under all kinds of open‐circuit faults. Moreover, with the introduction of the neutral point current, the machine can work under triple‐phase open‐circuit faults. In conclusion, the proposed control scheme based on the FPSL inverter expands the fault‐tolerant operation capability of the five‐phase PMSM. The experiment results prove the effectiveness of the proposed current regulation on increasing average torque or reducing copper loss under fault‐tolerant operation.

Fault-Tolerance Performance Analysis of a Five-Phase Permanent-Magnet Linear Synchronous Machine

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Fault-Tolerant Operation for Single-Phase Open Circuit of Dual-Armature Flux-Switching Permanent Magnet Machine by Connecting Neutral Points

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Analysis of Vibration Characteristics of Twelve-Phase Permanent Magnet Synchronous Motor under Different Fault Tolerance Strategies

Fault-tolerant oriented control of modular linear switched-flux permanent magnet machine

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

Fault-tolerant Control Strategy for Five-phase Permanent Magnetic Synchronous Motor under Single Phase Open-circuit Fault Condition

Design and Optimization of Five-Phase Fault-Tolerant In-Wheel Permanent Machine with Low Mutual-Inductance

Control strategy for a four-phase fault-tolerant permanent-magnet synchronous machine

Harmonic Analysis And Fault-Tolerant Capability Of A Semi-12-Phase Permanent-Magnet Synchronous Machine Used For Evs

Research on a Four-Phase Fault-Tolerant Permanent-Magnet Machine for Aerospace Application

Single-Phase Short-Circuit Fault Tolerant Control for Five-Phase Permanent Magnet Machines with Copper Loss Reduction

Research on a 20-Slot/22-Pole Five-Phase Fault-Tolerant PMSM Used for Four-Wheel-Drive Electric Vehicles

Simple fault tolerant control of dual three-phase PMSM under one phase open-circuited condition

Fault-Tolerant Control Strategy for Five-Phase PMSM with Third-Harmonic Current Injection

Analysis and Fault-Tolerant Control for Dual-Three-Phase PMSM Based on Virtual Healthy Model

A Consequent-Pole Five-Phase Fault-Tolerant Permanent-Magnet Synchronous Machine for Electric Vehicles

Fault‐tolerant operation for five‐phase permanent magnet synchronous machine drives with five‐phase six‐leg inverter