Abstract:This paper presents the design and test results for a dual-lane fault-tolerant PM motor for a safety critical aircraft actuator. Motor topology has been chosen to meet the system availability and reliability criterion considering principal faults that can occur within the motor including winding open circuit, line to line and phase to ground short circuits. The motor has two 3-phase windings which are powered from two independent inverters connected to different power supplies. The motor control strategy employs a healthy winding channel to have the capability to drive the load with the other winding channel short circuited in a faulted condition. The windings are designed to have a high impedance to limit the short circuit current to 1 p.u. A rectangular winding conductor is chosen to achieve a higher slot fill factor and for better manufacturability, which would also minimise the probability of turn to turn faults due to its thicker insulation. The effect of lateral magnetic pull has been considered to determine the locations of the dual-lane windings. Performance has been predicted by finite element analysis in healthy and faulted conditions. A prototype machine has been built and tested. Test results agree with the analysis in healthy and most of faulted conditions. However, measured drag torque with shorted windings is greater than the prediction at higher speeds, which is thought to be the effect of eddy currents in the conductors and magnets. It has confirmed that the induced current in a shorted turn is greatly affected by its location and the induced current may not be limited to 1 p.u. by short circuiting the machine phase terminals.

A Dual-Winding Fault-Tolerant Motor Drive System Based on the Redundancy Bridge Arm

The controller design for permanent magnet motor with complete electrical double redundancy structure

Multiphase Power Converter Drive for Fault-Tolerant Machine Development in Aerospace Applications

A New Fault Tolerant Drive and Control strategy with Double Y Connection for Six-phase Permanent-magnet Machine

A redundant flux-switching permanent magnet motor drive for fault-tolerant applications

Development of a Fault-Tolerant Permanent-Magnet Synchronous Motor

A Unified Open Switch Fault-Tolerant Control Method for Dual-Redundancy Permanent Magnet Synchronous Motor

Fault-Tolerant Brushless DC Motor Drive for Electro-Hydrostatic Actuation System in Aerospace Application

Performance Evaluation of A Fault-Tolerant Decoupled Dual-Channel Switched Reluctance Motor Drive under Open-Circuits

Control System Design of Redundancy High Voltage BLDCM

Robust Control of Fault-Tolerant Permanent-Magnet Synchronous Motor for Aerospace Application With Guaranteed Fault Switch Process

An Effective Design of and Experimental Research on Dual-Redundancy BrushLess DC Motor (BLDCM)

Research on a Six-Phase Permanent Magnet Synchronous Motor System at Dual-Redundant and Fault Tolerant Modes in Aviation Application

Twofold Fail-Work Remedy for Reconfigurable Driver and Windings of Four-Phase Permanent Magnet Fault-Tolerant Motor System

Fault-Tolerant Inverter for High-Speed Low-Inductance BLDC Drives in Aerospace Applications

Implementation of Dual Winding Brushless DC Motor Fault Tolerant Control System

Short-Circuit Fault-Tolerant Topology and Control Strategy for Active Magnetic Bearing Drive Based on Shared Bridge Arm

Fault-Tolerant Control of Half-Centralized Open-End Winding Motor Drive System Considering Open-Circuit Faults

Design and test results for dual-lane fault-tolerant PM motor for safety critical aircraft actuator

Fault-Tolerant Control for Open-Winding Permanent Magnet Compact In-Wheel Motor Drive System

Design of the Fault-Tolerant Control System for Space Robotic Joint