Abstract:This paper presents the design and test results for a dual-lane fault-tolerant PM motor for a safety critical aircraft actuator. Motor topology has been chosen to meet the system availability and reliability criterion considering principal faults that can occur within the motor including winding open circuit, line to line and phase to ground short circuits. The motor has two 3-phase windings which are powered from two independent inverters connected to different power supplies. The motor control strategy employs a healthy winding channel to have the capability to drive the load with the other winding channel short circuited in a faulted condition. The windings are designed to have a high impedance to limit the short circuit current to 1 p.u. A rectangular winding conductor is chosen to achieve a higher slot fill factor and for better manufacturability, which would also minimise the probability of turn to turn faults due to its thicker insulation. The effect of lateral magnetic pull has been considered to determine the locations of the dual-lane windings. Performance has been predicted by finite element analysis in healthy and faulted conditions. A prototype machine has been built and tested. Test results agree with the analysis in healthy and most of faulted conditions. However, measured drag torque with shorted windings is greater than the prediction at higher speeds, which is thought to be the effect of eddy currents in the conductors and magnets. It has confirmed that the induced current in a shorted turn is greatly affected by its location and the induced current may not be limited to 1 p.u. by short circuiting the machine phase terminals.

A 5-Phase Fault-Tolerant Brushless Permanent Magnet Motor Drive for an Aircraft Thin Wing Surface Actuator

A Brushless DC motor design for an aircraft electro-hydraulic actuation system

Fault-Tolerant Brushless DC Motor Drive for Electro-Hydrostatic Actuation System in Aerospace Application

Design of a Five-Phase Brushless DC Motor for a Safety Critical Aerospace Application

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Development of Integrated Hydrostatic-Driven Electric Generator

Multiphase Power Converter Drive for Fault-Tolerant Machine Development in Aerospace Applications

A Single Sided Matrix Converter Drive for a Brushless DC Motor in Aerospace Applications.

Optimization Of The Five Phase Fault Tolerant Motor Based On Ansoft Simulation

Design and Testing of a Four-Phase Fault-Tolerant Permanent-Magnet Machine for an Engine Fuel Pump

A Fault-Tolerant Direct Torque Control Strategy for A Brushless Dc Motor Driven by A Single Sided Matrix Converter

Thermal analysis of a fluid immersed brushless DC motor for aerospace applications

Direct Torque Control for Brushless DC Motors in Aerospace Applications with Single Sided Matrix Converters with Reduced Torque Ripple

Design and test results for dual-lane fault-tolerant PM motor for safety critical aircraft actuator

A review of high-speed electro-hydrostatic actuator pumps in aerospace applications: Challenges and solutions

Principle And Realization Of A 5-Phase Pm Bearingless Motor Drive

Design and Application of a Fault Detection Method Based on Adaptive Filters and Rotational Speed Estimation for an Electro-Hydrostatic Actuator

Modeling and Control of a Novel Electro-Hydrostatic Actuator with a Three-Ports Hydraulic Pump

Fault-Tolerance Analysis Of Multi-Phase Single Sided Matrix Converter For Brushless Dc Drives

Optimised design of electric actuators for more electric aircraft considering machining and assembly errors

Study of the Dynamic Properties of the Miniature Electro-Hydrostatic Actuator