Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In the present work, the process chain in tube production by roll forming of the steel 34MnB5 was examined in more detail. The process chain consisting of the steps (i) roll forming, (ii) HFI welding, and then (iii) straightening and final calibration was mapped using the finite element method. In addition to the pipe geometry, the residual stress distribution was considered as an essential target value for the assessment of the performance of the tubes under service conditions. The objective of the project is to describe the manufacturing process and thus the processing induced residual stress distributions as realistically as possible. For a more detailed characterization of the process and above all for the validation of the numerical simulations, experimental residual stress analyses were carried out for the final state of the tubes using complementary analysis methods. The contour method was used to determine the 2D-distribution of residual stresses across the transverse and longitudinal sections of the manufactured pipes. These measurements were supplemented by local residual stress analyses using the incremental hole drilling method and X-ray residual stress analyses. The work thus pursues both a methodical approach to the analysis of the internal stresses induced by the process using complementary methods and also a manufacturing approach to the analysis and evaluation of the production chain. In particular for the axial components of the residual stresses, it can be shown that experimentally determined residual stresses correlate well with the numerically calculated values. The contour method is excellently suited to monitor the uneven distribution of the internal stresses over the pipe cross-section. The results of the simulation show that the overall residual stress distribution that is determined using the contour method mainly results from the plastic strains introduced by the roll forming process. X-ray and hole drilling analyses are shown to be more suitable for measuring locally present residual stresses at defined positions on the outer tube surface. In this way it can be shown that the simulation approach described provides an accurate model of the process.

IMPLEMENTATION OF LONGITUDINAL WELDING STRESSES INTO STRUCTURAL CALCULATION OF STEEL STRUCTURES

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Welding-induced stresses and distortion in high-strength steel T-joints: Numerical and experimental study

Experimental and numerical analysis of residual stresses induced by the manufacturing process of longitudinal welded tubes

Simplified residual stress and distortion calculations of multi-pass welds and their possible influence on result quality

An Eulerian thermomechanical elastic–viscoplastic model with isotropic and directional hardening applied to computational welding mechanics

Load analyses of welded high-strength steel structures using image correlation and diffraction techniques

Effect of welding residual stress on the performance of CFST tubular joints

Numerical Simulation of the Stress-Strain State of a PAW-MIG-Welded 1561 Aluminum Alloy Butt Joint Produced Under Different Process Modes

Three-dimensional finite element analysis on welding residual stresses of construction steel

Finite Element Analysis on Stress Distribution on Section of Steel Columns Reinforced by Welding under Load

Experimental and numerical investigation on Local-Overall interactive buckling behavior of welded I-Section steel columns

Three-dimensional finite element modelling of welding residual stresses of medium carbon steel pipes with consideration of solid-state austenite-martensite transformation and post-weld heat treatment

Numerical and experimental study on thermal-metallurgical-mechanical behavior of high-strength steel welded joint

Numerical Investigations On Combined Effect Of Welding Residual Stress And Axial Compressive Load On Buckling Capacity Of Thin Low Carbon Steel Plates

Residual Stress Of High Strength Steel Welded Sections

Numerical Simulation of Welding for Residual Stress Prediction of Low Carbon Steel

Finite element simulation of multi-layer repair welding and experimental investigation of the residual stress fields in steel welded components

Welding under service conditions — Resulting weld quality and fatigue strength assessment

Finite Element Analysis And Design Method Study On The Interactive Buckling Of Welded Steel Members Under Axial Compression

In Situ Analysis of Stress and Microstructure Evolution during Welding of High-Alloy Steels Using Energy-Dispersive X-Ray Diffraction