Welding under service conditions — Resulting weld quality and fatigue strength assessment

Florian Begemann,Johanna Müller,Julian Unglaub,Klaus Dilger,Klaus Thiele,Jonas Hensel

DOI: https://doi.org/10.1016/j.engfailanal.2024.108142

IF: 4

2024-03-03

Engineering Failure Analysis

Abstract:Steel structures, such as bridges, must be continuously maintained. Due to increasing traffic loads, design and execution shortcomings, many steel bridges are subject to various types of damage, such as cracks. The bridges must be maintained by crack removal and re-welding the cracks. During this work, the bridge is closed for traffic in order to suppress the crack flank movement during welding. As a result, traffic loads on other routes are higher, which increases further damage on detour routes and subsequently additional welding work and costs on these structures. Therefore, the aim is to provide a method that allows welding work on steel structures under running traffic, respectively under cyclic loads. First, measurements at a representative steel bridge were conducted to derive gap opening parameters of amplitude and frequency for welding tests under cyclic loads. In a test setup for reproducible and comparable welding tests, specimen were welded under cyclic loads. Deep grinding of the root layer allowed defect-free welding within the range of 0.1 mm amplitude at a frequency of 2 Hz loadings. For such welds, the weld quality and the fatigue strength was comparable to the standard requirements.

engineering, mechanical,materials science, characterization & testing