Abstract:The non-oxide-reinforced phase AlN-SiC solid solution with high performance was successfully synthesized in the resin-bonded Al-Si-SiC composites under flowing nitrogen at 1300 °C. The AlN-SiC solid solution was synthesized by three paths of liquid-solid, gas-solid and gas-gas reactions through modulation of Al/Si ratio, and controllable microstructure of AlN-SiC solid solution was attained. The phase composition and microstructure of the sintered samples were characterized by XRD and SEM, combined with thermodynamics, the formation mechanism of AlN-SiC solid solution was investigated and the reaction model was established. Al was not detected while Si was detested by XRD. Granular, short columnar and whisker-like AlN-SiC solid solution were generated and their positions varied. As the temperature increases, the partial pressure of oxygen decreases due to the oxidation of Al, Si and SiC on the surface of the sample, inside the sample, the active oxidation takes place, generating Al2O(g), SiO(g) and CO(g). Due to the low oxygen partial pressure, Al is preferentially nitrided to form a thin AlN layer on its surface. The AlN layer is broken as the temperature increases, then liquid Al with carbon from resin begins to flow, leaving the residual shell of AlN in situ. When it flows to the surface of Si, Al-Sialloy is formed locally inside the Si particles under the wetting effect of C, then hexagonal AlN-SiC solid solution is formed inside the Si shell. Part of SiO(g) + CO(g) diffuses into the interior of the AlN residual shell and reacts by aggregation to form a granular AlN-SiC solid solution in the shell wall; others diffuses into the pores of the sample for vapor deposition, and finally forms stacked hexagonal flaky whiskers. The in-situ generated of AlN-SiC solid solution with multiple morphologies in the composite plays a joint toughening effect, which can significantly enhance the comprehensive performance of the composite. In this experiment, the synthesis of AlN-SiC solid solution without sintering aids under normal pressure at a low temperature. It is expected to be applied to the blast furnace and to realize the longevity of blast furnace.

CRN synthesis of β-SiAlON from a nanocomposite precursor of mesoporous silica–alumina (Al-SBA-15) with poly 4-vinyl pyridine

Preparation of transparent AlON from powders synthesized by novel CRN method

Carbothermal Reduction Synthesis of Aluminum Nitride from Al(OH)3/C/PVB Slurries Prepared by Three-Roll Mixing

Solid-state NMR and XRD study of α-SiAlON powders prepared by combustion synthesis

Facile synthesis of a carbon-rich SiAlCN precursor and investigation of its structural evolution during the polymer-ceramic conversion process

Rapid synthesis of AlON powders by nitriding combustion synthesis precursor

Optimizing AlN hydrolysis process to fabricate coated modified powders for improving the properties of Si 3 N 4 /SiAlON ceramics prepared by Vat Photopolymerization

MAS NMR, TPR, and TEM Studies of the Interaction of NiMo with Alumina and Silica–alumina Supports

Effect of Si3N4 mesophase on the formation of Al2OC-AlNss in resin-bonded Al–Al2O3 composites

Controllable Synthesis of High-purity β-SiAlON Powder

Reactive synthesis of alumina-boron nitride composites

Exploration of an atomic‐scale boron additive in SiAlON ceramics

In‐situ synthesis of 15R‐Sialon from Al‐Si 3 N 4 ‐Al 2 O 3 composite at 1500°C via liquid‐phase sintering

Combustion Synthesis of β-Si<sub>3</sub>N<sub>4</sub> and β-SiAlON with Elongated Prismatic Micro-Crystals by Adding SrCO<sub>3</sub> and NH<sub>4</sub>F

In-Situ Reactive Synthesis of AlN-SiC Composites and Solid Solutions

Combustion Synthesis Of Beta-Si3n4 And Beta-Sialon With Elongated Prismatic Micro-Crystals By Adding Srco3 And Nh4f

Controllable Synthesis of High-purity β-SiAlON Powder: Controllable Synthesis of High-purity β-SiAlON Powder

Formation mechanism of AlN-SiC solid solution with multiple morphologies in Al-Si-SiC composites under flowing nitrogen at 1300 °C

Synthesis of titanium nitride via hybrid nanocomposites based on mesoporous TiO2/acrylonitrile

Formation of β-SiAlON micropalings consisting of nanorods during combustion synthesis

Gas‐Phase and Solid‐State Simultaneous Mechanism for Two‐Step Carbothermal AlON Formation