Abstract:The greatest challenge in the subsequent processing of alumina ceramic slit arrays is the strength of the cutting wall. Because of its high brittleness, the fracture toughness of the wall has become one of the most important factors limiting the cutting quality. In the process of laser cutting alumina ceramics, α-γ reverse phase transformation is caused by the lattice dislocation effect due to instantaneous impact of high-energy beam, which can be induced in the heating/melting process and retained in the rapid cooling process. Generally speaking, due to the metastable characteristics of γ-Al2O3 lattice structure, the density, hardness and mechanical strength of the phase change products are obviously lower than α-Al2O3. However, the looser structure endows γ-Al2O3 with higher shear deformation component and fracture toughness, which potentially generates self-reinforcing effect when attached to the substrate. By controlling the material removal mode, i.e. vapor-to-melt ratio, the effects of different phase transformation content and distribution on the wall of slit array is discussed to reveal the phenomenon and mechanism of α-γ phase transformation self-reinforcing. The results show that the thickness of phase transformation layer and mass fraction of γ-Al2O3 both decrease with the increase of rvmr and the existence of phase transformation layer will slightly reduce the Vickers hardness of residual molten layer. However, a thinner phase transformation layer can simultaneously enhance the fracture toughness of the slit wall. Through the observation of the micromorphology and the comprehensive evaluation of the mechanical properties of the slit wall, it can be concluded that, under the appropriate vapor-to-melt ratio parameters (stable state of the molten layer and good cutting quality), the material is removed in time, and a small amount of phase transformation products contained in the residual molten layer can produce a self-reinforcing effect on the cutting slit.

Alpha alumina synthesis by laser treatment of bi-phasic nanowires

Unidirectional Crystal Orientation of Dual-Phase Ni3Al-Based Alloy via Laser Irradiation

Alpha-to-gamma phase transformation self-reinforcing of Alumina Ceramic Slit Array in Nd:YAG Laser Cutting Based on Vapor-to-melt Ratio Controlling

The surface softening mechanism of AlN ceramic by laser treatment

Surface Treatment of Alumina-Based Ceramics Using Combined Laser Sources

Crystallographic and morphological textures in laser surface modified alumina ceramic

Reactive Laser Ablation Synthesis of Nanosize Alumina Powder

Alumina–zirconium ceramics synthesis by selective laser sintering/melting

A New Method for Direct Welding of Alumina and Zirconia Ceramics by Ultrashort Pulse Laser for High Temperature Application

Preparation of α- Al2 O3 thin films by electron cyclotron resonance plasma-assisted pulsed laser deposition and heat annealing

Photoluminescence and Infrared Properties of Alpha-Al2o3 Nanowires and Nanobelts

Melt-grown behaviour of heat treated high-purity alumina ceramics prepared by laser directed energy deposition

In-Situ Reaction Deposition Of Alumina Ceramic Film By Laser-Induced Vacuum Arc

Wetting tuning of Al/B 4 C interface via femtosecond laser irradiation

Preparation Of Alpha-Al2o3 Thin Films By Electron Cyclotron Resonance Plasma-Assisted Pulsed Laser Deposition And Heat Annealing

Simulation and Experimental Study on Group Hole Laser Ablation on AL2O3 Ceramics

In-situ synthesis of nitrides and oxides through controlling reactive gas atmosphere during laser-powder bed fusion of Fe-12Cr-6Al

Laser drilling of alumina ceramic substrates: A review

Study of the Effect of Laser Treatment on the Initial Oxidation Behaviour of Al‐coated NiCrAlY Bond‐coat

Micromachining Porous Alumina Ceramic for High Quality Trimming of Turbine Blade Cores Via Double Femtosecond Laser Scanning

Flame-Assisted Laser Polishing of Alumina Ceramic Surface Properties