Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In the present work, the process chain in tube production by roll forming of the steel 34MnB5 was examined in more detail. The process chain consisting of the steps (i) roll forming, (ii) HFI welding, and then (iii) straightening and final calibration was mapped using the finite element method. In addition to the pipe geometry, the residual stress distribution was considered as an essential target value for the assessment of the performance of the tubes under service conditions. The objective of the project is to describe the manufacturing process and thus the processing induced residual stress distributions as realistically as possible. For a more detailed characterization of the process and above all for the validation of the numerical simulations, experimental residual stress analyses were carried out for the final state of the tubes using complementary analysis methods. The contour method was used to determine the 2D-distribution of residual stresses across the transverse and longitudinal sections of the manufactured pipes. These measurements were supplemented by local residual stress analyses using the incremental hole drilling method and X-ray residual stress analyses. The work thus pursues both a methodical approach to the analysis of the internal stresses induced by the process using complementary methods and also a manufacturing approach to the analysis and evaluation of the production chain. In particular for the axial components of the residual stresses, it can be shown that experimentally determined residual stresses correlate well with the numerically calculated values. The contour method is excellently suited to monitor the uneven distribution of the internal stresses over the pipe cross-section. The results of the simulation show that the overall residual stress distribution that is determined using the contour method mainly results from the plastic strains introduced by the roll forming process. X-ray and hole drilling analyses are shown to be more suitable for measuring locally present residual stresses at defined positions on the outer tube surface. In this way it can be shown that the simulation approach described provides an accurate model of the process.

Stress Evaluation in the Blank Critical Region During Extrusion of the Pipe Blank into the Hole

STRESS-STRAIN STATE OF THIN-WALLED PIPE BLANKS DURING CRIMPING IN A CURVED AXISYMMETRIC MATRIX

Stress Analysis and Assessment of Stream Setting Vessel Based on Elastic Contact Element Method

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Stress analysis of double-walled pipes undergone mechanical drawing process

RADIAL EXTRUSION OF A PIPE BILLET WITH INTERNAL LEDGE. DETERMINATION OF KINEMATIC AND STRESS STATES

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Numerical Analysis of Limit Load and Reference Stress of Defective Pipelines under Multi-Loading Systems

Stress Analysis and Performance Evaluation of Flange Spool Subjected to Pressure

Experimental and numerical analysis of residual stresses induced by the manufacturing process of longitudinal welded tubes

Numerical Analysis of Temperature Fields and Thermal Stress Fields in Heating Process of Large-Diameter Seamless Steel Pipe Blanks

Analysis of Sheet Metal Extrusion Process Using Finite Element Method

Stress Analysis and Evaluation of Special Shape Pressure Pipe

Numerical analysis of process induced stress field for composite filament wound vessel with metal liner

Comprehensive assessment of the production of a pipe billet with a flange by forging at various temperature conditions

Effect of welding axial stresses on the strength of a welded pipe joint with a defect

Numerical and Experimental Investigation on Limit Load of Elbow with Local Thinning Area

A Study of Fine Blanking Process by Fem Simulation

Numerical analysis of stress & strain and thickness variation in single point incremental forming of tailor welded steel blanks

Stress distribution of sleeve structure applied in hydrostatic extrusion cylinder

COMPUTATIONAL AND EXPERIMENTAL STUDY OF THE STRESS-STRAIN STATE OF A PIPE UNDER EXTERNAL RADIAL LOAD, INTERNAL PRESSURE AND TEMPERATURE DIFFERENCE