Abstract:In the present work, the orientation characteristics of residual grains during hot deformation of an age-hardening Ni-Fe-Cr alloy (Alloy 925) at different conditions were systematically analyzed through high-resolution electron back-scatter diffraction. Based on the measurement of the kernel average misorientation, the density of geometrical necessary dislocations (GNDs) was further calculated. The orientation-dependent deformation mechanism of the residual grains was also discussed using Schmid factor difference ratio (SFDR) analysis. The results show that the deformed microstructure features typical “necklace” structures. Many distorted twin boundaries can be observed within the residual grains at 950 °C. When the deformation temperature increases to 1150 °C, the volume fraction of dynamic recrystallization (DRX) increases, leading to the extensive formation of primary Σ3 twin boundaries. Additionally, the GNDs are widely distributed in the residual grains, while they are rare for the recrystallized grains. The maximum GND density value can be obtained at the interface of “soft–hard” grains. The GND density also increases at higher strain rates, and the number of DRX grains significantly affects the distribution of the GND density. Moreover, based on the calculations and SFDR analysis, it can be summarized that the {100} and {111} grains are prone to deform in the uniserial slip mode and the multiple slip mode, respectively.

Directional recrystallisation in nickel based high temperature alloy

The Influence of Pre-Annealing on Recrystallization in Heavily Cold-Rolled Nickel

Recovery and Recrystallization as a Function of Deformed Microstructure Orientation in Coarse Grained Cold-Rolled Ni

Development of the Cube Texture at Low Annealing Temperatures in Highly Rolled Pure Nickel

Orientation-Dependent Characteristics for Residual Grains During Hot Deformation of Nickel-Based Alloy 925

Deformation And Annealing Textures Of Extruded And Cold Rolled Pure Ni Single Crystals Of Cube Orientation

Recrystallization Texture in Nickel Heavily Deformed by Accumulative Roll Bonding

Formation of annealing twins during primary recrystallization of two low stacking fault energy Ni-based alloys

Development and Stability During High Temperature Annealing of the Cube Texture in Rolled Ni Substrate Materials

Role of As-Cast Dendritic Microstructure in Recrystallization of a Ni-based Single Crystal Superalloy

Growth of large crystallites of Co37Ni34Al29 ferromagnetic shape memory alloys under super-high temperature gradient directional solidification

Analysis of the Growth of Individual Grains During Recrystallization in Pure Nickel

Experimental Investigation on Recrystallization Mechanism of a Ni-base Single Crystal Superalloy

Effect of recrystallisation on microstructural evolution and mechanical properties of single crystal nickel base superalloy CMSX-2 Part 1 - Microstructural evolution during recrystallisation of single crystal

Effect of Orientation on the Microstructure of Nickel‐based Crystalline Superalloys

EBSD Analyses on Recovery and Recrystallization of High Purity Cold Rolled Nickel

The effect of deformation temperature on recrystallization in a Ni-based single crystal superalloys

Effect of cross cold rolling and annealing on microstructure and texture in pure nickel

Influence of directional solidification variables on the microstructure and crystal orientation of AM3 under high thermal gradient

The Effect of Directional Recrystallization on the Low Cycle Fatigue Response of a Powder Metallurgy Nickel-Based Superalloy at Elevated Temperatures

Microstructure evolution of nanostructured Ni3Al during annealing