Abstract:The p‐type doping of silicon nanowires grown by the vapor‐liquid‐solid mechanism is adjusted, pursuing a maximum performance, by in situ addition of variable amounts of diborane. The thermoelectric properties of individual nanowires with different carrier concentrations are measured. Optimized nanowires integrated into micro‐machined thermoelectric generators are characterized in real conditions. Low‐contact resistances allow the use of high‐density architectures with series‐connected devices. Semiconductor nanowires demonstrate outstanding properties within a wide range of application fields, including energy harvesting. Consequently, increasing attention has been focused on silicon nanowires for thermoelectric power generation after their successful implementation in miniaturized devices. In this work, the effect of tuning the p‐type doping level in silicon nanowires is studied in thermoelectric micro‐generators. In situ heavily boron‐doped silicon nanowires are grown by the vapor‐liquid‐solid mechanism in a chemical vapor deposition reactor. Variable quantities of dopant gas—diborane or B2H6—are used to control the doping level and study the direct influence on the thermoelectric properties of the nanowires. The relationship between dopant partial pressure and resulting carrier concentration is evaluated, and all thermoelectric properties are studied as a function of each doping level. A maximum power factor of 2.0 ± 0.2 mW mK−2 is found for a carrier concentration of 2.5 × 1019 cm−3, corresponding to a figure of merit of zT = 0.04 at near room temperature. Optimized nanowires are included in a micro‐machined thermoelectric generator, yielding an open circuit voltage of 4.5 mV and maximum power output of 1.08 μW cm−2 upon hot surfaces at 250 °C.

Fabrication of High-Temperature-Stable Thermoelectric Generator Modules Based on Nanocrystalline Silicon

Transitioning from Si to SiGe Nanowires as Thermoelectric Material in Silicon-Based Microgenerators

Silicon integrated circuit thermoelectric generators with a high specific power generation capacity

Superior Thermoelectric Performance of SiGe Nanowires Epitaxially Integrated into Thermal Micro-Harvesters

Modeling, properties, and fabrication of a micromachined thermoelectric generator

Design, Fabrication, and Characterization of CMOS MEMS-Based Thermoelectric Power Generators

Silicon-based thermoelectrics made from a boron-doped silicon dioxide nanocomposite

Fabrication of a Silicide Thermoelectric Module Employing Fractional Factorial Design Principles

Monolithic Carbon Nanotube Film Thermoelectric Generator

Manufacturing thermoelectric micro modules using micromachined silicon wafers

On‐Chip Thermoelectric Devices Based on Standard Silicon Processing

Manufacturing of Tubular Thermoelectric Generator by Plasma Spray and Its Thermoelectric Property

Converting Natural Diatomite into Nanoporous Silicon for Eco-Friendly Thermoelectric Energy Conversion

Upscaling Thermoelectrics: Micron-Thick, Half-a-Meter-Long Carbon Nanotube Films with Monolithic Integration of p- and n-Legs

Flexible Carbon Nanotube‐Epitaxially Grown Nanocrystals for Micro‐Thermoelectric Modules

Fabrication And Evaluation Of Microscale Thermoelectric Modules Of Bi2te3-Based Alloys

Single-Crystal Silicon Thermoelectrics by Phonon Engineering

Interface and Surface Engineering Realized High Efficiency of 13% and Improved Thermal Stability in Mg3Sb1.5Bi0.5‐Based Thermoelectric Generation Devices

Tuning the Thermoelectric Properties of Boron‐Doped Silicon Nanowires Integrated into a Micro‐Harvester

Operating Temperature Dependency of Power Generation Capacity in Silicon Planar-Integrated Microthermoelectric Generators

Enhancing the performance of thermoelectric generators using novel segmental arrangement of multi-functional gradient materials