Tuning the Thermoelectric Properties of Boron‐Doped Silicon Nanowires Integrated into a Micro‐Harvester

Jose M. Sojo‐Gordillo,Denise Estrada‐Wiese,Carolina Duque‐Sierra,Gerard Gadea‐Díez,Marc Salleras,Luis Fonseca,Alex Morata,Albert Tarancón
DOI: https://doi.org/10.1002/admt.202101715
IF: 6.8
2022-05-05
Advanced Materials Technologies
Abstract:The p‐type doping of silicon nanowires grown by the vapor‐liquid‐solid mechanism is adjusted, pursuing a maximum performance, by in situ addition of variable amounts of diborane. The thermoelectric properties of individual nanowires with different carrier concentrations are measured. Optimized nanowires integrated into micro‐machined thermoelectric generators are characterized in real conditions. Low‐contact resistances allow the use of high‐density architectures with series‐connected devices. Semiconductor nanowires demonstrate outstanding properties within a wide range of application fields, including energy harvesting. Consequently, increasing attention has been focused on silicon nanowires for thermoelectric power generation after their successful implementation in miniaturized devices. In this work, the effect of tuning the p‐type doping level in silicon nanowires is studied in thermoelectric micro‐generators. In situ heavily boron‐doped silicon nanowires are grown by the vapor‐liquid‐solid mechanism in a chemical vapor deposition reactor. Variable quantities of dopant gas—diborane or B2H6—are used to control the doping level and study the direct influence on the thermoelectric properties of the nanowires. The relationship between dopant partial pressure and resulting carrier concentration is evaluated, and all thermoelectric properties are studied as a function of each doping level. A maximum power factor of 2.0 ± 0.2 mW mK−2 is found for a carrier concentration of 2.5 × 1019 cm−3, corresponding to a figure of merit of zT = 0.04 at near room temperature. Optimized nanowires are included in a micro‐machined thermoelectric generator, yielding an open circuit voltage of 4.5 mV and maximum power output of 1.08 μW cm−2 upon hot surfaces at 250 °C.
materials science, multidisciplinary
What problem does this paper attempt to address?