Abstract:The shear characteristics of calcareous sand, a typical deposit in the South China Sea, could significantly influence the safety and stability of marine structures. Previous studies showed that many factors, such as temperature and surface roughness, could affect the mobilized shear strength between the calcareous sand and steel surface. Therefore, studies on the shear behaviors of the steel-sand interface under various thermal conditions are necessary. In this study, a new multifunctional sediment shear system has been developed and employed to investigate the shear performance. For this purpose, steel plates with different surface roughness were tested under various normal stress values, shear displacement rates and temperatures. Shear strength and deformation were analyzed using test data to reveal the relationships between several factors and the shear strength of the steel-sand interface. Results from test demonstrate that the interfacial shear strength on rough steel interfaces will be 1.45–3.15 times higher than that on the smooth steel interface. Besides, the shear strength of the interface rises significantly with the roughness of the steel plate. The peak friction angle increases rapidly at the start and then tends to stabilize with the increase of normalized roughness. The interfacial shear strength could be enhanced in low-temperature environments but would reduce in high-temperature environments, e.g. the energy pile, particularly under low normal stress. The shear displacement rate also has a positive effect on the interface shear strength for most cases in this study. Finally, a new nonlinear function is proposed to describe the peak friction angle ratio of foundation interface to consider the effect of temperature and shear displacement rate reasonably.

Effect of Particle Size Distribution on Soil-Steel Interface Shear Behavior

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Experimental Investigation into Cyclic Shear Behaviors in the Interface Between Steel and Crushed Mudstone Particles

Monotonic Behavior of Interface Shear Between Carbonate Sands and Steel

The Effect of Cemented Soil Strength on the Frictional Capacity of Precast Concrete Pile–cemented Soil Interface

Particle size effects on coarse soil-geogrid interface response in cyclic and post-cyclic direct shear tests

Study on surface roughness effect on shear behavior of concrete-soil interface

Experimental Study on Friction Capacity of Pile-Stabilized Soil Interface

Shear Band Between Steel and Carbonate Sand Under Monotonic and Cyclic Loading

Laboratory tests on the frictional capacity of core pile - cemented soil interface

Influence of soil particle size on monotonic and cyclic direct shear behaviors of geogrid-soil interface

Effect of particle gradation on static and dynamic direct shear properties of geogrid-sand interface

Experimental Study of Cyclic Shear Stiffness and Damping Ratio of Carbonate Sand-Steel Interface

Investigation on the cyclic shear properties of steel-crushed red mudstone particles interface

Effects of the soil water content and relative roughness on the shear strength of silt and steel plate interface

Experimental study of interface performance between calcareous sand and steel pile with different surface roughness and temperatures

Experimental study on frictional capacity of square pile-cemented soil interface

Study on Cyclic Shear Properties of Siliceous Sand–Steel Interface under Different Normal Loading Conditions

Experimental study on the shear characteristics of different pile-soil interfaces and the influencing factors

Visualized direct shear test of the interface between gravelly sand and concrete pipe

Effect Analysis of Steel Sheet Pile Supporting for Utility Tunnel Foundation Pit in Water-Rich Soft Soil