Abstract:Large-displacement shear appears between pile shaft and its surrounding soil during the penetration process, and cyclic shear is the typical feature in subsequent service load condition. In this paper, a series of interface shear tests have been conducted to investigate the sand-steel interface behaviors under large-displacement and cyclic shear. Three types of particles (quartz sand, carbonate sand and steel bead) and two normal boundary conditions (constant normal load, CNL; constant normal stiffness, CNS) were used in these tests. To simulate the large displacement shear process for monotonic installed pile, the large-displacement shear is performed using monotonic shear method. It is found that under the large-displacement shear with CNL condition, the quartz sand and carbonate sand show different breakage degrees and modes. Obvious particle breakage changes both the particle gradation and sample densification, which are the main reasons for the increase of interface friction angle. While for the cyclic shear with CNS condition, the interface strength shows a quick degradation feature, which is mainly affected by the initial shape of particles. It is also found that the previous interface shear plays a key role in this kind of degradation. When the shear displacement is small, the degradation is promoted with only a small amount of sand breakage. But if the sand breakage is significant under the large-displacement shear, abundant broken fine particles fill into the void and make the sand sample much denser. So, the degradation trend of interface strength will be suppressed. It is suggested that the previous large-displacement shear process for displacement pile should be adequately considered in the design.

Experimental study on frictional capacity of square pile-cemented soil interface

Experimental study on the frictional capacity of square pile–cemented soil interface with different surface roughness

Laboratory tests on the frictional capacity of core pile - cemented soil interface

Experimental Study on Friction Capacity of Pile-Stabilized Soil Interface

The Effect of Cemented Soil Strength on the Frictional Capacity of Precast Concrete Pile–cemented Soil Interface

Experimental Study on Behavior of Composite Foundation with Rigid-Flexible Piles

Testing and Modeling the Behavior of Pre-Bored Grouting Planted Piles under Compression and Tension

In-situ test of bearing capacity behavior of composite foundation with rigid-flexible piles

Numerical Study of the Effect of Material Modulus Upon Cement-Soil Pile Composite Foundation

The frictional capacity of smooth concrete pipe pile–cemented soil interface for pre-bored grouted planted pile

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Study of Influence of Cushion on Settlement of Cement-Soil Mixing Pile Composite Foundation

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Field Test on the Influence of the Cemented Soil Around the Pile on the Lateral Bearing Capacity of Pile Foundation

Experimental Study on Direct Shear Performance of Concrete-Concrete Interface of Prefabricated Structure Sleeve Grouting Connection

Shaft Capacity of the Pre-Bored Grouted Planted Pile in Dense Sand

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

Effect of Cemented Soil Properties on the Behavior of Pre-Bored Grouted Planted Nodular Piles under Compression

Study on surface roughness effect on shear behavior of concrete-soil interface