Abstract:The shear characteristics of calcareous sand, a typical deposit in the South China Sea, could significantly influence the safety and stability of marine structures. Previous studies showed that many factors, such as temperature and surface roughness, could affect the mobilized shear strength between the calcareous sand and steel surface. Therefore, studies on the shear behaviors of the steel-sand interface under various thermal conditions are necessary. In this study, a new multifunctional sediment shear system has been developed and employed to investigate the shear performance. For this purpose, steel plates with different surface roughness were tested under various normal stress values, shear displacement rates and temperatures. Shear strength and deformation were analyzed using test data to reveal the relationships between several factors and the shear strength of the steel-sand interface. Results from test demonstrate that the interfacial shear strength on rough steel interfaces will be 1.45–3.15 times higher than that on the smooth steel interface. Besides, the shear strength of the interface rises significantly with the roughness of the steel plate. The peak friction angle increases rapidly at the start and then tends to stabilize with the increase of normalized roughness. The interfacial shear strength could be enhanced in low-temperature environments but would reduce in high-temperature environments, e.g. the energy pile, particularly under low normal stress. The shear displacement rate also has a positive effect on the interface shear strength for most cases in this study. Finally, a new nonlinear function is proposed to describe the peak friction angle ratio of foundation interface to consider the effect of temperature and shear displacement rate reasonably.

Experimental study on the frictional capacity of square pile–cemented soil interface with different surface roughness

Experimental study on frictional capacity of square pile-cemented soil interface

Laboratory tests on the frictional capacity of core pile - cemented soil interface

Experimental Study on Friction Capacity of Pile-Stabilized Soil Interface

Experimental Study on Behavior of Composite Foundation with Rigid-Flexible Piles

The Effect of Cemented Soil Strength on the Frictional Capacity of Precast Concrete Pile–cemented Soil Interface

Study on surface roughness effect on shear behavior of concrete-soil interface

In-situ Experiment on Urban Road Subgrade Improved by Plain Concrete Pile and Mixed-in-place Pile

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Study on Bearing Behavior of Pure-friction Long Pile in Soft Clay

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Shaft Capacity of the Pre-Bored Grouted Planted Pile in Dense Sand

Testing and Modeling the Behavior of Pre-Bored Grouting Planted Piles under Compression and Tension

The frictional capacity of smooth concrete pipe pile–cemented soil interface for pre-bored grouted planted pile

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Experimental study of interface performance between calcareous sand and steel pile with different surface roughness and temperatures

Experimental study on the shear characteristics of different pile-soil interfaces and the influencing factors

Test and prediction for the shear behavior of the sand–irregular concrete interface under constant and dynamic normal loading

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

Shear Band Between Steel and Carbonate Sand Under Monotonic and Cyclic Loading