Abstract:Large-displacement shear appears between pile shaft and its surrounding soil during the penetration process, and cyclic shear is the typical feature in subsequent service load condition. In this paper, a series of interface shear tests have been conducted to investigate the sand-steel interface behaviors under large-displacement and cyclic shear. Three types of particles (quartz sand, carbonate sand and steel bead) and two normal boundary conditions (constant normal load, CNL; constant normal stiffness, CNS) were used in these tests. To simulate the large displacement shear process for monotonic installed pile, the large-displacement shear is performed using monotonic shear method. It is found that under the large-displacement shear with CNL condition, the quartz sand and carbonate sand show different breakage degrees and modes. Obvious particle breakage changes both the particle gradation and sample densification, which are the main reasons for the increase of interface friction angle. While for the cyclic shear with CNS condition, the interface strength shows a quick degradation feature, which is mainly affected by the initial shape of particles. It is also found that the previous interface shear plays a key role in this kind of degradation. When the shear displacement is small, the degradation is promoted with only a small amount of sand breakage. But if the sand breakage is significant under the large-displacement shear, abundant broken fine particles fill into the void and make the sand sample much denser. So, the degradation trend of interface strength will be suppressed. It is suggested that the previous large-displacement shear process for displacement pile should be adequately considered in the design.

Effect of particle gradation on static and dynamic direct shear properties of geogrid-sand interface

Influence of soil particle size on monotonic and cyclic direct shear behaviors of geogrid-soil interface

Cyclic and post-cyclic direct shear behaviors of geogrid-sand interface with different soil densities

Particle size effects on coarse soil-geogrid interface response in cyclic and post-cyclic direct shear tests

Effects of direct shear characteristics of sand-geogrid interface under different aperture ratios

Cyclic and post-cyclic shear behavior of sand-geogrid interface under different shear rates

Effect of Particle-Size Gradation on Coarse Sand-Geotextile Interface Response in Cyclic and Postcyclic Direct Shear Test

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

Effect of aperture ratio on the cyclic shear behaviour of aggregate-geogrid interfaces

Dynamic Shear Behavior of Interface for Clay Reinforced with Geogrid Encapsulated in Thin Layers of Sand

Coupling effects of particle shape and cyclic shear history on shear properties of coarse-grained soil–geogrid interface

Effects of Grain Size and Moisture Content on the Strength of Geogrid-Reinforced Sand in Direct Shear Mode

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Interface Shear Behavior of Geogrid-Reinforced Calcareous Sand Under Large-Scale Monotonic Direct Shear

Effects of particle size and gradation on shear behavior of interface between crushed stone and structure

Analysis of cyclic shear characteristics of reinforced soil interfaces under cyclic loading and unloading

Investigation of shear mechanical behaviors of geogrid-coral sand interfaces

Effects of Particle Size on the Shear Behavior of Coarse Grained Soils Reinforced with Geogrid

Effect of Particle Regularity on the Bidirectional Cyclic Shear Behavior of Geogrid–Granular Material Interface

Determining the Shear Strength Properties of a Soil-geogrid Interface Using a Large-scale Direct Shear Test Apparatus

Analysis of sand-woven geotextile interface shear behavior using DEM