Abstract:During the milling process of thin-walled workpiece, chatter is the major obstacle in achieving desired accuracy and productivity of the final part due to its low rigidity. In this paper, a novel method is proposed to mitigate the chatter of the thin-walled workpiece by submerging the milling system in viscous fluid. To evaluate the effectiveness of the presented method, the influence of the viscous fluid on the milling force coefficients is investigated, and the modal parameters of the thin-walled workpiece are identified under dry and viscous conditions respectively. It is found that compared with the dry milling, the milling force coefficients reduce significantly under viscous fluid condition due to the lubrication. Besides, the damping of the milling system increases substantially under viscous fluid condition, and the natural frequencies of the milling system decrease owing to the added mass of the viscous fluid. The milling stability lobe diagrams are predicted based on the numerical integration method by taking multiple modes of the thin-walled workpiece into consideration. A series of milling tests are conducted to verify the stability lobe diagrams and confirm the effectiveness of the proposed approach. The vibration displacement signals are measured and then analyzed in time-frequency domain to demonstrate the state of the milling process. Moreover, the surface finishes of the thin-walled workpieces are compared. The results show that the thin-walled workpiece chatter could be suppressed greatly with the proposed method and higher stability limit can be achieved. (C) 2018 Elsevier Ltd. All rights reserved.

Research on milling stability of thin-walled parts based on improved multi-frequency solution

Experimental and simulation study on chatter stability region of integral impeller with non-uniform allowance.

Parameter Optimization of Time-Varying Stiffness Method for Chatter Suppression Based on Magnetorheological Fluid-Controlled Boring Bar

Numerical Simulation and Analysis of Symmetry and Step-symmetry Milling of Aerospace Thin-walled Workpiece

A State-of-the-Art Review on Chatter Stability in Machining Thin−Walled Parts

Milling Stability Prediction and Adaptive Chatter Suppression Considering Helix Angle and Bending

Investigation on chatter stability of thin-walled parts milling considering the effects of fixture support force and tool position

A new solution for stability prediction in flexible part milling

A New Chatter Stability Criterion in Milling Process Simulation

Stability analysis of thin-walled parts end milling considering cutting depth regeneration effect

Chatter Mitigation for the Milling of Thin-Walled Workpiece

Milling Stability Prediction for Flexible Workpiece Using Dynamics of Coupled Machining System

Prediction of Time-Varying Chatter Stability: Effect of Tool Wear

Time-varying dynamics updating method for chatter prediction in thin-walled part milling process

Time-Varying Chatter Frequency Characteristics in Thin-Walled Workpiece Milling with B-Spline Wavelet on Interval Finite Element Method

An improved time-varying stability analysis of micro milling considering tool wear

Tool path optimization with stability constraints for ball-end milling cutters based on frequency domain controlling strategy

Chatter suppression analysis for variable pitch cutter in milling

Study the effect of anti-vibration edge length on process stability of milling thin-walled Ti-6Al-4V alloy

Chatter stability analysis and prediction for elliptical ultrasonic vibration-assisted milling process

Chatter Stability Analysis in Micro-milling with Aerostatic Spindle Considering Speed Effect