Abstract:A plasma-assisted chemical looping system for the production of H2 (PCLH) was investigated in this study. This system allows the partial oxidation of CH4 at mild temperatures (573–773 K). Four active oxygen carriers: Fe2O3, NiO-impregnated Fe2O3 (NiO/Fe2O3), SrFeO3−δ and NiO-impregnated SrFeO3−δ (NiO/SrFeO3−δ) were compared, each working both as a packed material for the plasma reactor and an oxygen source for the partial oxidation of CH4. Similar conversions of CH4, and low yields of H2 were obtained in Fe2O3 and SrFeO3−δ. It was concluded that in these cases, H2 was mainly produced from direct cracking of CH4 by plasma. In contrast, when using NiO/Fe2O3 and NiO/SrFeO3−δ, substantial production of H2 was achieved. It is proposed that there is a synergistic effect between the catalyst and the oxygen carrier; the presence of the metallic Ni phase was responsible for catalysing the production of H2, and the oxygen from the support helped prevent the build-up of coke. As a result, the activity of Ni was continuously maintained for H2 production. The chemical loop is closed with the oxygen carriers being regenerated in air with plasma and then used in the next looping cycle. The high H2 production capability in NiO/Fe2O3 was repeatable; whilst, NiO/SrFeO3−δ deactivated in the second and third cycles. Amongst the temperatures studied, NiO/Fe2O3 at 673 K resulted in the best performance for H2-rich gas production. A further increase in the operating temperature led to a total combustion of CH4.

Pentalithium Ferrite (Li5FeO4) as Highly Active Material for Hydrogen Production in the Chemical Looping Partial Oxidation of Methane

Utilizing high entropy oxide (Ni0.2Co0.2Ca0.2Cu0.2Mg0.2)Fe2O4 in chemical looping process for highly efficient and stable hydrogen production

The Use of Ferrites As Highly Active Oxygen Storage Materials for Chemical Looping Hydrogen Production under Intermediate Temperature

Iron Oxides with Gadolinium-Doped Cerium Oxides As Active Supports for Chemical Looping Hydrogen Production

Bifunctional Catalyst NiFe–MgAl for Hydrogen Production from Chemical Looping Ethanol Reforming

Mn-Fe-Al-O Mixed Spinel Oxides As Oxygen Carrier for Chemical Looping Hydrogen Production with CO2 Capture

High-Purity Hydrogen Obtained via a Plasma-Assisted Chemical Looping Process Using Perovskite-Supported Iron Oxides as Oxygen Carriers

Chemical looping reforming of biomass based pyrolysis gas coupling with chemical looping hydrogen by using Fe/Ni/Al oxygen carriers derived from LDH precursors

Use of Heavy Fraction of Bio-Oil As Fuel for Hydrogen Production in Iron-Based Chemical Looping Process

Chemical Looping Conversion of Methane via Fe2O3-LaFeO3 Calcined from LaFe-MOF Precursor

Earth Abundant Spinel for Hydrogen Production in a Chemical Looping Scheme at 550 °C

Enhanced performance of LaFeO3 oxygen carriers by NiO for chemical looping partial oxidation of methane

Performance of Fe2O3/LaFeO3 as oxygen carrier in chemical-looping hydrogen generation

Promoting CO2 methanation via ligand-stabilized metal oxide clusters as hydrogen-donating motifs

Mid-temperature Chemical Looping Methane Reforming for Hydrogen Production Via Iron-Based Oxygen Carrier Particles

Promoted methane conversion to syngas over Fe-based garnets via chemical looping

Evaluation of Fe Substitution in Perovskite LaMnO3 for the Production of High Purity Syngas and Hydrogen

Oxygen Vacancy Modulation for Enhanced Hydrogen Production via Chemical Looping Water-Gas Shift

A High-Performance Ternary Ferrite-Spinel Material for Hydrogen Storage Via Chemical Looping Redox Cycles

Cu–Fe–Al–O Mixed Spinel Oxides As Oxygen Carrier for Chemical Looping Hydrogen Generation

H2 production from a plasma-assisted chemical looping system from the partial oxidation of CH4 at mild temperatures