Abstract:Chemical looping hydrogen (CLH) process with renewable energy sources as fuel shows the potential of producing pure hydrogen with inherent capture of CO2 in a low-cost and sustainable way. The heavy fraction (HF) of bio-oil, derived from the fast pyrolysis of biomass and characterized as an energy carrier with difficulty in upgrading itself to bio-fuel or chemicals, was used in this study to generate H-2. Four low-cost iron-based oxygen carriers including an ilmenite and three iron ores were initially evaluated with respect to their reducibility and the ability to minimize carbon or iron carbide (Fe3C) formation in a thermogravimetric analyzer (TGA). The reactivity and cyclic performance of the selected best candidate was then assessed in a laboratory scale fixed-bed reactor with HF bio-oil as fuel. The screening test in TGA showed that ilmenite was superior over the three iron ores in terms of promoting CO conversion and minimizing carbon or Fe3C formation. Ilmenite could maintain its increasing reducibility with the increase of surrounding CO concentration, in contrast with the iron ores that were deactivated seriously by the formed carbon or Fe3C. Subsequent CLH test with ilmenite and HF bio-oil showed that the reducibility and H-2 production capacity of ilmenite were strongly dependent on the operating temperature. The steam oxidation step at 950 degrees C yielded H-2 concentration and hydrogen yield exceeding all of those observed at the other investigated temperatures because of the deepest reduction degree of ilmenite at 950 degrees C. The decrease in the reducibility and H-2 production capacity of ilmenite in the cyclic test could be ascribed to the poorer physical structure of ilmenite with cycles. Copyright (C) 2014, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Use of Heavy Fraction of Bio-Oil As Fuel for Hydrogen Production in Iron-Based Chemical Looping Process

Natural Iron Ore as Oxygen Carrier Modified with Rare Earth Metal for Chemical Looping Hydrogen Production

Numerical Study on the Process of Chemical Looping Hydrogen Production with Multiple Circulating Fluidized Bed Reactors

Bio-oil heavy fraction for hydrogen production by iron-based oxygen carrier redox cycle

Bio-Oil Heavy Fraction as a Feedstock for Hydrogen Generation via Chemical Looping Process: Reactor Design and Hydrodynamic Analysis

Renewable hydrogen production from biogas using iron-based chemical looping technology

Chemical looping hydrogen production with modified iron ore as oxygen carriers using biomass pyrolysis gas as fuel

Reactivity of Iron-based Oxygen Carriers Prepared by Wet and Dry Mixing Methods for Hydrogen Production Via Biomass Derived Syngas Chemical Looping

Reactivity of iron oxide as an oxygen carrier for chemical-looping hydrogen production

Investigations on oxygen carriers derived from natural ores or industrial solid wastes for chemical looping hydrogen generation using biomass pyrolysis gas

Hydrogen Production from the Steam-Iron Process with Direct Reduction of Iron Oxide by Chemical Looping Combustion of Coal Char

Production of clean hydrogen fuel on a bifunctional iron catalyst via chemical loop reforming of methanol

Performance of Ceo2-Modified Iron-Based Oxygen Carrier in the Chemical Looping Hydrogen Generation Process

Utilizing high entropy oxide (Ni0.2Co0.2Ca0.2Cu0.2Mg0.2)Fe2O4 in chemical looping process for highly efficient and stable hydrogen production

The Use of Ferrites As Highly Active Oxygen Storage Materials for Chemical Looping Hydrogen Production under Intermediate Temperature

Performance evaluation of rare earth (La, Ce and Y) modified CoFe2O4 oxygen carriers in chemical looping hydrogen generation from hydrogen-rich syngas

A short-cut chemical looping hydrogen generation system by using iron-based material from steel industry

Stepwise Reduction Kinetics of Iron-Based Oxygen Carriers by CO/CO 2 Mixture Gases for Chemical Looping Hydrogen Generation

High-purity hydrogen production from real biomass pyrolysis vapors via a chemical looping process

Pentalithium Ferrite (Li5FeO4) as Highly Active Material for Hydrogen Production in the Chemical Looping Partial Oxidation of Methane

Optimization of nickel-iron bimetallic oxides for coproduction of hydrogen and syngas in chemical looping reforming with water splitting process