Abstract:Chemical looping hydrogen (CLH) process with renewable energy sources as fuel shows the potential of producing pure hydrogen with inherent capture of CO2 in a low-cost and sustainable way. The heavy fraction (HF) of bio-oil, derived from the fast pyrolysis of biomass and characterized as an energy carrier with difficulty in upgrading itself to bio-fuel or chemicals, was used in this study to generate H-2. Four low-cost iron-based oxygen carriers including an ilmenite and three iron ores were initially evaluated with respect to their reducibility and the ability to minimize carbon or iron carbide (Fe3C) formation in a thermogravimetric analyzer (TGA). The reactivity and cyclic performance of the selected best candidate was then assessed in a laboratory scale fixed-bed reactor with HF bio-oil as fuel. The screening test in TGA showed that ilmenite was superior over the three iron ores in terms of promoting CO conversion and minimizing carbon or Fe3C formation. Ilmenite could maintain its increasing reducibility with the increase of surrounding CO concentration, in contrast with the iron ores that were deactivated seriously by the formed carbon or Fe3C. Subsequent CLH test with ilmenite and HF bio-oil showed that the reducibility and H-2 production capacity of ilmenite were strongly dependent on the operating temperature. The steam oxidation step at 950 degrees C yielded H-2 concentration and hydrogen yield exceeding all of those observed at the other investigated temperatures because of the deepest reduction degree of ilmenite at 950 degrees C. The decrease in the reducibility and H-2 production capacity of ilmenite in the cyclic test could be ascribed to the poorer physical structure of ilmenite with cycles. Copyright (C) 2014, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Bio-Oil Heavy Fraction as a Feedstock for Hydrogen Generation via Chemical Looping Process: Reactor Design and Hydrodynamic Analysis

Hydrodynamic Study on the Riser of Chemical Looping Hydrogen Production System with Multiple Fluidized Bed Reactors

Numerical Study on the Process of Chemical Looping Hydrogen Production with Multiple Circulating Fluidized Bed Reactors

Use of Heavy Fraction of Bio-Oil As Fuel for Hydrogen Production in Iron-Based Chemical Looping Process

Advances in hydrogen production using chemical-looping technology

Bio-oil heavy fraction for hydrogen production by iron-based oxygen carrier redox cycle

New Process Combining Fe-Based Chemical Looping and Biomass Pyrolysis for Cogeneration of Hydrogen, Biochar, Bio-Oil and Electricity with In-Suit CO2 Separation

High-purity hydrogen production from real biomass pyrolysis vapors via a chemical looping process

Chemical Looping Reforming of Glycerol for Continuous H2 Production by Moving-Bed Reactors: Simulation and Experiment

Chemical Looping Reforming of Toluene As Bio-Oil Model Compound Via NiFe2O4@SBA-15 for Hydrogen-Rich Syngas Production

Chemical looping reforming of waste cooking oil in packed bed reactor

Simultaneous CO 2 Capture and H 2 Generation Using Fe 2 O 3 /al 2 O 3 and Fe 2 O 3 /cuo/al 2 O 3 As Oxygen Carriers in Single Packed Bed Reactor Via Chemical Looping Process

Chemical Looping Conversion of Gaseous and Liquid Fuels for Chemical Production: A Review

Renewable hydrogen production from biogas using iron-based chemical looping technology

CFD-DEM simulation of chemical looping hydrogen generation in a moving bed reactor

Hydrodynamic simulation of fuel-reactor in chemical looping combustion process

Review of Hydrogen Production from the Steam-Iron Process by Chemical-Looping Combustion

STEAM REFORMING BIO-OIL TO PRODUCE HYDROGEN IN A FLUIDIZED BED REACTOR

Chemical Looping Enhanced Oil Shale-to-Liquid Fuels Process: Modeling, Parameter Optimization, and Performance Analysis

CaO-Assisted Alkaline Liquid Waste Drives Corn Stalk Chemical Looping Gasification for Hydrogen Production

Catalytic Steam Reforming of Fast Pyrolysis Bio‐Oil in Fixed Bed and Fluidized Bed Reactors