Abstract:The abrasion mechanism in solid-solid contact mode of the chemical mechanical polishing (CMP) process is investigated in detail. Based on assumptions of plastic contact over wafer-abrasive and pad-abrasive interfaces, the normal distribution of abrasive size and an assumed periodic roughness of pad surface, a novel model is developed for material removal in CMP. The basic model is MMR = rho (w)NVol(removed), where rho (w) is the density of wafer, N the number of active abrasives, and Vol(removed) the volume of material removed by a single abrasive. The model proposed integrates process parameters including pressure and velocity and other important input parameters including the wafer hardness, pad hardness, pad roughness, abrasive size, and abrasive geometry into the same formulation to predict the material removal rate (MRR). An interface between the chemical effect and mechanical effect has been constructed through a fitting parameter H-w, "dynamical" hardness value of the wafer surface, in the model. It reflects the influences of chemicals on the mechanical material removal. The fluid effect in the current model is attributed to the number of active abrasives. It is found that the nonlinear down pressure dependence of material removal rate is related to a probability density function of the abrasive size and the elastic deformation of the pad. Compared with experimental results, the model accurately predicts MRR. With further verification of the model, a better understanding of the fundamental mechanism involved in material removal in the CMP process, particularly different roles played by the consumables and their interactions, can be obtained.

Modeling and Experimental Analysis of the Material Removal Rate in the Chemical Mechanical Planarization of Dielectric Films and Bare Silicon Wafers

A Coupled Material Removal Model for Chemical Mechanical Polishing Processes

Material Removal Mechanism in Chemical Mechanical Polishing: Theory and Modeling

A Chemical Mechanical Polishing Model Based on the Viscous Flow of the Amorphous Layer

Material Removal Regions in Chemical Mechanical Planarization for Submicron Integrated Circuit Fabrication: Coupling Effects of Slurry Chemicals, Abrasive Size Distribution,and Wafer-Pad Contact Area

Analytical Modelling of Material Removal in Copper Chemical Mechanical Polishing Incorporating the Scratch Hardness of the Passivated Layer on Copper Thin Film Wafer

A Model for Mechanical Wear and Abrasive Particle Adhesion during the Chemical Mechanical Polishing Process

A chemical mechanical polishing model incorporating both the chemical and mechanical effects

Non-continuum Material Removal Mechanism of Surface Polishing with Ultra Precision

A plasticity-based model of material removal in chemical-mechanical polishing (CMP)

Investigation of Material Removal Mechanism of Silicon Wafer in the Chemical Mechanical Polishing Process Using Molecular Dynamics Simulation Method

Mechanical Model of Nanoparticles for Material Removal in Chemical Mechanical Polishing Process

Modeling the Chemical-Mechanical Synergy During Copper CMP

Surface Morphology Evolution during Chemical Mechanical Polishing Based on Microscale Material Removal Modeling for Monocrystalline Silicon

Characterization of Pad–Wafer Contact Area and Distance in Chemical-Mechanical Polishing

Chemical mechanical polishing: Theory and experiment

Wear phenomena in chemical mechanical polishing

Analysis on Pad Effects in Chemical Mechanical Polishing

Effects of grinding-induced surface topography on the material removal mechanism of silicon chemical mechanical polishing

A Preliminary Model Accounting for the Suction Pressure in CMP Process

A model for chemical–mechanical polishing of a material surface based on contact mechanics