Abstract:The abrasion mechanism in solid-solid contact mode of the chemical mechanical polishing (CMP) process is investigated in detail. Based on assumptions of plastic contact over wafer-abrasive and pad-abrasive interfaces, the normal distribution of abrasive size and an assumed periodic roughness of pad surface, a novel model is developed for material removal in CMP. The basic model is MMR = rho (w)NVol(removed), where rho (w) is the density of wafer, N the number of active abrasives, and Vol(removed) the volume of material removed by a single abrasive. The model proposed integrates process parameters including pressure and velocity and other important input parameters including the wafer hardness, pad hardness, pad roughness, abrasive size, and abrasive geometry into the same formulation to predict the material removal rate (MRR). An interface between the chemical effect and mechanical effect has been constructed through a fitting parameter H-w, "dynamical" hardness value of the wafer surface, in the model. It reflects the influences of chemicals on the mechanical material removal. The fluid effect in the current model is attributed to the number of active abrasives. It is found that the nonlinear down pressure dependence of material removal rate is related to a probability density function of the abrasive size and the elastic deformation of the pad. Compared with experimental results, the model accurately predicts MRR. With further verification of the model, a better understanding of the fundamental mechanism involved in material removal in the CMP process, particularly different roles played by the consumables and their interactions, can be obtained.

Modeling the Chemical-Mechanical Synergy During Copper CMP

A chemical mechanical polishing model incorporating both the chemical and mechanical effects

Material Removal Mechanism of Copper CMP from a Chemical–Mechanical Synergy Perspective

Analytical Modelling of Material Removal in Copper Chemical Mechanical Polishing Incorporating the Scratch Hardness of the Passivated Layer on Copper Thin Film Wafer

Scratch-Concerned Yield Modeling for Ic Manufacturing Involved with A Chemical Mechanical Polishing Process

A Theoretical Model Incorporating Both the Nano-Scale Material Removal and Wafer Global Uniformity During Planarization Process

Material Removal Mechanism in Chemical Mechanical Polishing: Theory and Modeling

A Coupled Material Removal Model for Chemical Mechanical Polishing Processes

A Chemical Mechanical Polishing Model Based on the Viscous Flow of the Amorphous Layer

Molecular Modeling of the Mechanical Effect in the Chemical Mechanical Polishing Process

Mechanical Model of Nanoparticles for Material Removal in Chemical Mechanical Polishing Process

Material Removal Regions in Chemical Mechanical Planarization for Submicron Integrated Circuit Fabrication: Coupling Effects of Slurry Chemicals, Abrasive Size Distribution,and Wafer-Pad Contact Area

Modeling the microscale contact status in chemical mechanical polishing process

Effects of abrasive size distribution in chemical mechanical planarization: Modeling and verification

Non-continuum Material Removal Mechanism of Surface Polishing with Ultra Precision

Modeling and Experimental Analysis of the Material Removal Rate in the Chemical Mechanical Planarization of Dielectric Films and Bare Silicon Wafers

A plasticity-based model of material removal in chemical-mechanical polishing (CMP)

Tribo-chemical Behavior of Copper in Chemical Mechanical Planarization

Electrochemical investigation of copper passivation kinetics and its application to low-pressure CMP modeling

Study of mechano-electrochemical model: a numerical and experimental approach

A Model for Mechanical Wear and Abrasive Particle Adhesion during the Chemical Mechanical Polishing Process