Abstract:This study examines the laser-stricken damage to different alumina ceramic surfaces of different roughness through multi-physical field coupling simulations and laser-striking experiments. The surfaces of different morphologies can be described by waves of different frequencies and amplitudes, and the waves which are discretized can be described by rectangular microstructures of different heights. In this paper, we found that the reaction of roughness surfaces to gauss lasers stricken on them could be simulated by the reaction of rectangular microstructures of different heights to laser strike. The simulation was carried out through the multi-physical field coupling method. The distribution of temperature and stress on rectangular microstructure were examined after being treated by high energy laser. It was found that overhigh temperature and stress were the main causes of laser-stricken damage, but there existed a critical rectangular column height value. The microstructure became increasingly prone to damage and fall-off with the increase of the rectangular column's height, but it became decreasingly prone to damage after the rectangular column reached the critical value. In the experiments, seven roughness zones of alumina ceramic layer were chosen as sample surfaces for laser-striking experiment. The results showed that there was a critical roughness value at a fixed laser energy density. As a result, the amount of particles falling off the surfaces caused by laser strike was rising when the roughness was increasing. However, the amount of particles falling off the surfaces was decreasing after roughness reached the critical value. The critical rectangular column height value in the simulation corresponded to the critical roughness value in the experiment. Therefore, an appropriate selection of roughness is an important factor for obtaining high laser-stricken damage threshold.

Investigation on pulsed laser damage resistance of high-absorption ceramic coatings

Researches on Laser Damage Resistance of Optical Films

Antireflective Coatings Used for High-Power Co2-Laser

Studies on Infrared Absorption Loss of Antireflection Coatings on Germanium and Potassium Chloride Substrates at the Wavelength of 10.6μm by Photothermal Deflection Technique

Effect of the Dynamic Porous Structure Generation in Laser Irradiated Multi-Functional Coatings

Numerical Simulation and Experimental Investigation of Laser Ablation of Al2O3 Ceramic Coating

Accurate measurement for damage evolution of ceramics caused by nanosecond laser pulses with polarization spectrum imaging

Carbon fiber reinforced ZrC based ultra-high temperature ceramic matrix composite subjected to laser ablation: Ablation resistance, microstructure and damage mechanism

Toward improving the reflectivity of ablative heat-insulating coating under high-energy laser irradiation

Surface damage induced by micropores in transparent ceramics under nanosecond laser irradiation

Design and preparation of resin matrix composite coating with good ablation resistance performance under high-energy laser irradiation

Damage analysis and mechanism study of sol–gel coating over KDP crystal under multi-pulse of laser irradiation at low flux

Laser-induced damage properties of antireflective porous glasses

Laser pretreatment enhances the laser-induced damage threshold of MgAl_2O_4 transparent ceramics

Investigation of laser induced damage on K9 glass surface using multi-pulse laser

Nonlinear optical effects in polycrystalline transparent Al2O3 ceramics using femtosecond laser pulses—supercontinuum generation and laser damage

Simulation and Experimental Research on Laser-induced Damage of Porcelain Insulators

A review on ceramic coatings prepared by laser cladding technology

Design and preparation of composite coatings with increased reflectivity under high-energy continuous wave laser ablation

Investigating the material properties of HfO2/SiO2-based anti-reflection coatings during 1064 nm laser-induced breakdown in air and vacuum conditions

Study on Laser-Stricken Damage to Alumina Ceramic Layer of Different Surface Roughness