Abstract:Pure tungsten (W) is generally believed to be a preferred alternative material for kinetic penetrators once a "self-sharpening" effect can be realized by inducing adiabatic shear failure during high-speed impact. However, it is still a major challenge to trigger adiabatic shear bands (ASBs) in pure W with low ductility. In this work, we reported an improved adiabatic shear susceptibility of pure W by controlling the texture evolution during the pre-rolling process. As the rolling strain increased, the texture components and intensity underwent crucial variations to facilitate the appearance of ASBs. For comparative studies, we investigated the dynamic behavior of three kinds of W samples with different microstructural features at a wide range of temperatures (298K∼1473K) via SHPB system, including coarse-grained W (CGW), as-rolled W samples to the thickness reductions of 75% (75W) and 80% (80W). The experimental results revealed a transition of failure behavior from typical brittle fracture to adiabatic shear instability under uniaxial dynamic compression. Of particular interest was that although 75W and 80W exhibited almost the same mechanical properties after the similar rolling reductions, their dynamic instability behaviors differed remarkably with different spatial distributions of texture components. In the as-rolled 75W, two dominant texture components of {001} and {111} were alternate to form fully spaced layers. Under uniaxial compression, the {111} "hard orientation layers" became the obstacles to the propagation of ASBs. Fortunately, in 80W specimens the different {001} "soft orientation layers" were interconnected by the "soft bricks" of the same orientation, which provided pathways for the expansion of shear localization and ultimately the triggering of ASBs. Through subsequent crystal plasticity finite element (CPFEM) simulations, we further verified the effect of orientation distributions on the shear localization and thoroughly explained the formation mechanism of ASBs in the highly textured refractory metal. This may provide guidance for producing advanced materials for certain practical applications.

Mechanism of White Band (WB) Formation due to Rolling Contact Fatigue in Carburized SAE4320 Steel

White Etching Bands Formation Mechanisms Due to Rolling Contact Fatigue

White etching area damage induced by shear localization in rolling contact fatigue of bearing steel

The Evolution of White Etching Cracks (WECs) in Rolling Contact Fatigue-Tested 100Cr6 Steel

Further Investigations and Parametric Analysis of Microstructural Alterations under Rolling Contact Fatigue

Formation Mechanism and Influence of White Etching Area on Contact Fatigue Spalling of M50 Bearing Steel

The origin of microstructural alterations in M50 bearing steel undergoing rolling contact fatigue

Phase transformation in the subsurface of case carbonitrided bearing steels under rolling contact fatigue

Mechanism of fine granular area and white etching crack formation in AISI 52100 bearing steel

A Study on Decisive Early Stages in White Etching Crack Formation Induced by Lubrication

Tailoring the adiabatic shear susceptibility of pure tungsten via texture evolution

Microstructures of surface white layer and internal white adiabatic shear band

Fatigue and recrystallization evolution of carbide-free bainitic layer under high-stress rolling sliding contact

Rolling contact fatigue failure mechanism of bearing steel on different surface roughness levels under heavy load

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

Crystal plasticity modeling of grain boundary softening and fatigue in U75V pearlite steel under low strain conditions: A study of cyclic rolling contact fatigue

Derivative Analysis and Evaluation of Roll-slip Fretting Wear Mechanism of Ultra-thin-walled Bearings under High Service

A microstructural investigation of adiabatic shear bands in an interstitial free steel

The effect of retained austenite on rolling/sliding contact fatigue of high carbon steel

Effect of White Band on Quality of Billet Cast with F-EMS

Peridynamic Modeling of Hydrogen-Assisted White Etching Cracks in Bearing Steel under Rolling Contact Fatigue