Abstract:Hard turning is becoming increasingly considered by industry as a potential substitute for grinding. However, it is greatly hurdled by surface integrity problems such as tensile residual stress and white layer, which are generally found to have negative effects on the stress corrosion, wear resistance, and fatigue life of the machined parts. This paper investigates white layer formation and morphology in hard turning process using various process parameters, taking into account the effects of heat treatment which results in microstructure and hardness differences on bulk materials. Samples undergone three typical heat treatment processes are prepared and then machined using different cutting speeds and radial feed rates. Optical microscope, scanning electron microscope (SEM), and X-ray diffraction (XRD) are employed to analyze the microstructures of white layer and bulk materials after varies heat treatments and cutting processes. Through the studies, we find the existence of a cutting speed threshold, below which no white layer forms for both the low and medium-temperature tempering. The threshold value increases; however, the white layer thickness decreases under the same cutting conditions, for the low and medium-temperature tempering, respectively. Also, we find that the white layer thickness and the scattering of it along the cutting direction on the surface increases with cutting speed and radial feed rate. White layer with wavy morphology can be found in samples after quenching at high cutting speed. We first discover that the pitch of the white layer with wavy morphology is similar to the displacement of tool at the time a segment of the serrated chips forms. Also, the surface residual stresses of the samples are measured. Relationship between white layer and residual stresses is presented. Based on the relationship we reveal that high temperature is more dominant than volume expansion for white layer formation.

Effect of White Band on Quality of Billet Cast with F-EMS

Formation and effects of banded structures in 55SiCrA spring steel wire rod

Improvement of carbon segregation in billet by final-EMS, based on segmented continuous casting model

Study on the synergistic effect of electromagnetic stirring and mechanical reduction on the improvement of the internal homogeneity of high-carbon steel billet

Numerical and Experimental Study on Carbon Segregation in Shaped Billet of Medium Carbon Steel with Combined Electromagnetic Stirring.

Improving compositional homogeneity of CF53 steel products by modifying their solidification structure and F-EMS intensity

Mechanism of White Band (WB) Formation due to Rolling Contact Fatigue in Carburized SAE4320 Steel

Improving Inner Quality in Continuous Casting Rectangular Billets: Comparison Between Mechanical Soft Reduction and Final Electromagnetic Stirring

Quality Control of High Carbon Steel for Steel Wires

Influence of Electromagnetic Swirling Flow in Nozzle on Solidification Structure and Macrosegregation of Continuous Casting Square Billet

Effect on Position of Electromagnetic Stirring on Inclusion Behaviors in Billet

Effect of initial microstructure on microstructure evolution of bidirectional warm rolled medium carbon steel

Effects of Hot Rolled Shear Bands on Formability and Surface Ridging of an Ultra Purified 21%cr Ferritic Stainless Steel

Effect of Mold Electromagnetic Stirring and Final Electromagnetic Stirring on the Solidification Structure and Macrosegregation in Bloom Continuous Casting

Effect of Cr/Mn segregation on pearlite—martensite banded structure of high carbon bearing steel

White Etching Bands Formation Mechanisms Due to Rolling Contact Fatigue

Revealing the evolution mechanism from spot segregation to banded defect above the austenitization temperature

Modeling of the as-cast structure and macrosegregation in the continuous casting of a steel billet: Effect of M-EMS

Effects of Process Parameters on White Layer Formation and Morphology in Hard Turning of Aisi52100 Steel

Formation Mechanism and Influence of White Etching Area on Contact Fatigue Spalling of M50 Bearing Steel

The Role of Elements Partition and Austenite Grain Size in the Ferrite-Bainite Banding Formation during Hot Rolling