Abstract:Tip clearance refers to the radial distance from the tip of the engine rotor to the shroud, which significantly affects engine performance, as well as safety. The difference between the thermal and mechanical response of the components generates the "pinch point" clearance in the transient process, which is difficult to predict. This paper summarized a multidimensional transient model (MDTM) for clearance prediction, which was based on the temporal and spatial characteristics of components and verified by the fluid-solid-thermal coupling method (FSTM) on a single-stage turbine, and the computation cost of MDTM is only 1/1500 of FSTM. Therefore, MDTM is efficient for predicting tip clearance, especially in the early engine design stage. Meanwhile, the variant effects of different control strategies on the transient tip clearance of a baseline were explored through the approach. The control strategies consist of active clearance control methods, including controlling the cooling flow to the disk cavity and shaft speed variation time; and passive control methods, including the material type selection and geometry characteristic design. The pinch point and cruise clearance were controlled through different control strategies. Specifically, the material properties show the most significant effect on the cruise clearance (2.0% of the blade height), followed by the geometry characteristics (0.7% of the blade height). Meanwhile, the structural strength and temperature tolerance requirements should be considered first. Moreover, the mass flow rate control of the cooling flow to the disk cavity could be a potential method for tip clearance control, which affects the second pinch point and cruise clearance for 0.5% and 0.6% of the blade height, respectively. The study provides a theoretical basis for selecting a tip clearance control strategy.

A review of blade tip clearance–measuring technologies for gas turbine engines

Active Control System of Turbine Tip Clearance

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

A Comprehensive Study of Tip Clearance Control Based on a Multidimensional Transient Clearance Prediction Approach

Advances in the application of non-contact temperature measurement technology for aero-engine blade.

Techniques for blade tip clearance measurements with capacitive probes

Comparisons of blade tip phantom cooling effectiveness for two tip structures with three tip clearances

Dynamic blade tip clearance control of aero-engine by the integration of cooling air with fuel thermal management system

Transient Tip Clearance Prediction Model Considering Transient Radial Temperature Distribution of Discs in a Gas Turbine Engine

Research on Tip Clearance Measurement Technology of Aero-engine Blade Based on Optical Fiber Sensing System

A dynamic turbine tip clearance measurement method based on laser self-mixing interferometric ranging considering Doppler effect

A Machine Vision Method for Identifying Blade Tip Clearance in Wind Turbines

A Review of Tip Clearance in Propeller, Pump and Turbine

Calculation and Analysis for Transient Blade-Tip Radial Running Clearance of HPT

Dynamic Detection Method for Blade Tip Clearance of Aero-Engine in Assembled State Based on Linear Structured Light

System design and experimental research on tip clearance measurement of areo-engines by digital radiograph

Review on Mechanisms with Clearances and Its Future Application in the Internal Combustion Engine

Unsteady Analysis on the Effects of Tip Clearance Height on Hot Streak Migration Across Rotor Blade Tip Clearance

A Review Of Aero-Engine Turbine Blade Temperature Measurement

Numerical investigation on the influence of nonuniform tip clearance on rotor tip-clearance flow field structure

Experimental Investigation of Aerodynamic Performance due to Blade Tip Clearance in a Gas Turbine Rotor Cascade