Abstract:Tip clearance refers to the radial distance from the tip of the engine rotor to the shroud, which significantly affects engine performance, as well as safety. The difference between the thermal and mechanical response of the components generates the "pinch point" clearance in the transient process, which is difficult to predict. This paper summarized a multidimensional transient model (MDTM) for clearance prediction, which was based on the temporal and spatial characteristics of components and verified by the fluid-solid-thermal coupling method (FSTM) on a single-stage turbine, and the computation cost of MDTM is only 1/1500 of FSTM. Therefore, MDTM is efficient for predicting tip clearance, especially in the early engine design stage. Meanwhile, the variant effects of different control strategies on the transient tip clearance of a baseline were explored through the approach. The control strategies consist of active clearance control methods, including controlling the cooling flow to the disk cavity and shaft speed variation time; and passive control methods, including the material type selection and geometry characteristic design. The pinch point and cruise clearance were controlled through different control strategies. Specifically, the material properties show the most significant effect on the cruise clearance (2.0% of the blade height), followed by the geometry characteristics (0.7% of the blade height). Meanwhile, the structural strength and temperature tolerance requirements should be considered first. Moreover, the mass flow rate control of the cooling flow to the disk cavity could be a potential method for tip clearance control, which affects the second pinch point and cruise clearance for 0.5% and 0.6% of the blade height, respectively. The study provides a theoretical basis for selecting a tip clearance control strategy.

Calculation and Analysis for Transient Blade-Tip Radial Running Clearance of HPT

Nonlinear and Dynamic Analysis of HPT Blade-tip Radial Running Clearance

Probabilistic Design of HPT Blade-Tip Radial Running Clearance with Distributed Collaborative Response Surface Method

A Comprehensive Study of Tip Clearance Control Based on a Multidimensional Transient Clearance Prediction Approach

Reliability and Sensitivity Analyses of HPT Blade-Tip Radial Running Clearance Using Multiply Response Surface Model

Active Control System of Turbine Tip Clearance

Reliability Analysis for HPT Blade-tip Radial Running Clearance Based on DCRSM

Transient Tip Clearance Prediction Model Considering Transient Radial Temperature Distribution of Discs in a Gas Turbine Engine

Transient Probabilistic Analysis for Turbine Blade-Tip Radial Clearance with Multi-Component and Multi-Physics Fields Based on DCERSM

Dynamic Probabilistic Design Approach of High-Pressure Turbine Blade-Tip Radial Running Clearance

Probabilistic Analysis of Turbine Blade Radial Deformation for Aeroengine

Dynamic probabilistic analysis for turbine blade radial deformation

Transient State Flow and Heat Transfer Performance over the Flat Tip of HP Turbine

Aerothermal Optimization and Sensitivity Analysis of a Turbine Rotor Tip with a Circumferential Casing Groove Configuration

The Study Of Tip Clearance Of A Wide-Chord Fan Blade Of A High Bypass Ratio Turbo-Fan Engine

Numerical Investigation of the Blade Tip and Overtip Casing Aerothermal Performance in a High Pressure Turbine Stage

Numerical Investigation on the Effect of Tip Clearance on a Turbine Stage Flow-field and Aerodynamic Performance

Experimental Study of Turbine Blade Tip Heat Transfer with High-Speed Relative Casing Motion

Multi-Object Multi-Discipline Probabilistic Design of High-Pressure Turbine Blade-Tip Radial Running Clearance

Unsteady Analysis on the Effects of Tip Clearance Height on Hot Streak Migration Across Rotor Blade Tip Clearance

A tip clearance prediction model for multistage rotors and stators in aero-engines