Abstract:Ultra-thin flexible photovoltaic materials for solar cells, like transition metal di-chalcogenides (TMDCs), hold significant promise due to their advantageous properties in photon absorption and electronic transport, being composed of atomically thin 2D layered semiconductor materials. An essential 2D-layered substance, tungsten Disulfide (WS2), classified as a TMDC, has garnered substantial attention due to its notable chemical and physical characteristics. This work presents a novel method for getting good photovoltaic results using WS2 solar cells. The suggested configuration "Al/FTO/SnS2/WS2/CuO/Ni" comprises two absorber layers, which involves incorporating CuO as a supplementary absorber layer and SnS2 as the buffer layer. Several metals with varying work functions were investigated one at a time, therefore, Al and Ni were chosen for the front as well as back contact in order to produce a low resistance metal-semiconductor (M-S) interface. Additionally, aluminum (Al) and nickel (Ni), are commonly used due to their well-understood properties such as conductivity and thermal stability. Subsequently, an analysis was conducted to determine the effects of important influencing factors, such as operating temperature, layer thickness, defects density, and doping density of the absorber and buffer layers. The power conversion efficiency (PCE) was achieved approximately 30%, accompanied by an open circuit voltage (VOC) of 1.02 V, a short circuit current (JSC) of 34.35 mA/cm2, and a fill factor (FF) of 87.27%. This improvement was achieved by utilizing an Al/FTO/SnS2/WS2/CuO/Ni heterostructure. In comparison, the reference cell without CuO (single absorber) had a PCE of 21.74%, VOC of 0.88 V, JSC of 28.6 mA/cm2, and FF of 86.23%. The results obtained from an extensive numerical analysis and demonstrate the immense potential of the SnS2/WS2/CuO heterostructure, indicating a promising direction for the manufacturing of photovoltaic and photonic devices based on WS2-TMDCs. This study provides a systematic roadmap for the fabrication process as well as realization of low-cost high efficiency solar cell.

WS2: A New Window Layer Material for Solar Cell Application

Design and optimization of WS2 based high performance double absorber solar cell

Electronic and optical properties of ultra-thin 2D tungsten disulfide for photovoltaic applications

Microcrystalline silicon carbide window layers in thin film silicon solar cells

Microcrystalline Silicon‐carbon Alloys As Anti‐reflection Window Layers in High Efficiency Thin Film Silicon Solar Cells

Microcrystalline Silicon Thin Film Solar Cells with Microcrystalline Silicon Carbide Window Layers and Silicon Absorber Layers Both Prepared by Hot‐Wire CVD

Concurrent investigation of antimony chalcogenide (Sb2Se3 and Sb2S3)-based solar cells with a potential WS2 electron transport layer

Structural, optical and optoelectrical analysis of a new window layer based on ZnAl2S4 thin films

High-efficiency CdTe-based Thin-Film Solar Cells with Unltrathin CdS:O Window Layer and Processes with Post Annealing

Crystalline Silicon Heterojunction Solar Cells with Metal Oxide Window Layers

Development of 2nd Generation Thin Film Photovoltaics Based on CZTS Absorber Layer and ZnS Window Layer

Film Thickness of Transition Metal MoS2/CNFs Electrode Effect on Dye-Sensitized Solar Cell

Enhanced Photoelectrochemical Activity Realized from WS2 Thin Films Prepared by RF‐Magnetron Sputtering for Water Splitting

CdS Nanowire Layers of Enhanced Transmittance for Window Layer Applications in Thin Film Solar Cells

Wafer-scale 2D PtTe2 layers for high-efficiency mechanically flexible electro-thermal smart window applications

Synthesis and optical properties of large-area single-crystalline 2D semiconductor WS2 monolayer from chemical vapor deposition

Synthesis and optical properties of large-scale single-crystalline two-dimensional semiconductor WS2 monolayer from chemical vapor deposition

Performance evaluation of WS2 as buffer and Sb2S3 as hole transport layer in CZTS solar cell by numerical simulation

Cadmium sulfide nanowire arrays for window layer applications in solar cells

Toward Mass-Production of Transition Metal Dichalcogenide Solar Cells: Scalable Growth of Photovoltaic-Grade Multilayer WSe2 by Tungsten Selenization

A Simple Method to Produce an Aluminum Oxide-Passivated Tungsten Diselenide/n-Type Si Heterojunction Solar Cell with High Power Conversion Efficiency