Enhanced Photoelectrochemical Activity Realized from WS2 Thin Films Prepared by RF‐Magnetron Sputtering for Water Splitting

Somnath Ladhane,Shruti Shah,Pratibha Shinde,Ashvini Punde,Ashish Waghmare,Yogesh Hase,Bharat R. Bade,Vidya Doiphode,Swati N. Rahane,Dhanashri Kale,Sachin R. Rondiya,Mohit Prasad,Shashikant P. Patole,Sandesh R. Jadkar
DOI: https://doi.org/10.1002/celc.202400002
IF: 4
2024-02-21
ChemElectroChem
Abstract:WS2 for PEC splitting: In this article, we study the properties of WS2 thin films deposited using RF magnetron sputtering. We focus on structural, electrical, optical, and morphological properties in view of their use for PEC water splitting. By varying the RF power, we investigate its impact on the nanostructures and assess their potential for use in photoelectrochemical water splitting. We report the synthesis of tungsten sulfide (WS2) films using RF‐magnetron sputtering at different RF powers. X‐ray diffraction (XRD) data confirm the hexagonal crystal structure of WS2 with an average crystallite size of ∼44.54 Å. With increased RF power, the preferred orientation of WS2 crystallites shifts from (002) to (100). Linear sweep voltammetry (LSV) was used to assess the Photoelectrochemical (PEC) activity of WS2 films. The film deposited at 150 W demonstrated the highest photocurrent density of 5.44 mA/cm2. The 150 W film also showed a lower Tafel slope of ∼0.374 V/decade, indicating superior PEC activity. Mott Schottky's (MS) analysis revealed a notable shift in the flat band potential towards the negative side, suggesting a shifting of the Fermi level towards the conduction band. WS2 film grown at 150 W demonstrated a majority charge carrier density of 6.2×1021 cm−3 and a depletion layer width of 1.54 nm. The observed low charge transfer resistance of 155 Ω contributed to the enhanced PEC activity with a relaxation time constant of 37 ms. These properties suggest that WS2 can be suitable for PEC water splitting.
electrochemistry
What problem does this paper attempt to address?