Abstract:Cobalt silicide (CoSi2) islands have been formed by the deposition of thin films (~0.1 to 0.3 nm) of cobalt on clean Si(111) and Si(100) substrates in ultrahigh vacuum (UHV) followed by annealing to ~880 degrees C. Conducting atomic force microscopy has been performed on these islands to characterize and measure their current-voltage (I-V) characteristics. Current-voltage curves were analyzed using thermionic emission theory to obtain the Schottky barrier heights and ideality factors between the silicide islands and the silicon substrates. Current-voltage measurements were performed ex situ for samples ("passivated surfaces") where the silicon surface surrounding the islands was passivated with a native oxide. Other samples ("clean surfaces") remained in UHV while I-V curves were recorded. By comparing barrier heights and ideality factors for islands on both surfaces, the effects of the non-passivated surfaces on conduction were studied. The clean surface barrier heights were found to be ~0.2 to 0.3 eV below barrier heights measured from similar islands on passivated surfaces. The reduced Schottky barrier is mainly attributed to Fermi level pinning by non-passivated surface states of the clean silicon surface. However, the measured barrier heights of the clean surface islands are equivalent on both Si(111) and Si(100), suggesting that the non-passivated surfaces are influenced by cobalt impurities. Furthermore, the barrier heights of islands on the clean surfaces are lower than due to Fermi level pinning alone and the additional barrier height lowering is primarily attributed to spreading resistance effects. Schottky barrier inhomogeneity may also cause additional barrier height lowering and non-ideality in the contacts. The clean surface barrier heights decreased and the ideality factors increased with decreasing temperature, which is attributed to the temperature variation of the Fermi level.

Silver overlayers on (110) indium phosphide: film growth and Schottky barrier formation

Electronic Structure and Trilayer Growth of Indium Films on Si(111): a Photoemission Study

An Aes, Xps And Tds Study On The Growth And Property Of Silver Thin Film On The Pt(110)-(1 X 2) Surface

Surface Vs. Bulk Electronic Structure of Silver Determined by Photoemission

An AES, XPS and TDS study on the growth and property of silver thin film on the Pt( 1 1 0 )-(1×2) surface

An Atomic Bricklaying Rule During the Initial Growth of Silver Thin Film on the Pt(110)-(1×2) Surface

Study Of The Na-Si(111) 3x1 Interface Using Core-Level Photoemission Spectroscopy

Observation of a Surface Alloying-to-dealloying Transition During Growth of Bi on Ag(111)

Surface Electronic Structure and Morphology of Silver on Iron Oxide Films

Electron Energy Loss Spectroscopy, Low Energy Electron Diffraction, and Auger Electron Spectroscopy Study of Indium Overlayers on Si(111) and Si(100) Surfaces

Formation of the Schottky Barrier at (3 × 1)na/si(111) Surface

Quantized Electronic Structure and Growth of Pb Films on Highly Oriented Pyrolytic Graphite

Interface Layers in In0.532ga0.468as/Inp Superlattices

X-ray Diffraction Studies of Trilayer Oscillations in the Preferred Thickness of in Films on Si(111)

Aggregation of Organic Molecules on Silver Surface with the Balance Between Molecule–substrate Interaction and Intermolecular Interaction

An ab initio approach to anisotropic alloying into the Si(001) surface

Interface-Induced Complex Electronic Interference Structures in Ag Films on Ge(111)

Formation of Atomically Flat Silver Films on Gaas with A ''silver Mean'' Quasi Periodicity

Single Crystalline Silver Films for Plasmonics: From Monolayer to Optically Thick Film

Surface and Interface Properties of InSb Epitaxial Thin Films Grown on Gaas by Low Pressure Metalorganic Chemical Vapor Deposition

Conducting Atomic Force Microscopy Studies of Nanoscale Cobalt Silicide Schottky Barriers on Si(111) and Si(100)