Abstract:Copper oxide was synthesis by hydrothermal method using copper nano powder (30nm) and deionized water on quartz substrate. At temperature 100 °C, different experimental time ranging from (24–72 h). Different copper oxide phase was presented in X-Ray diffraction analyzer, the crystal size increased as the reaction time increased as it calculated using scherrer equation to be (21.1–32.03 nm), and Williamson Hall plot to be (40.3–87.7 nm). Also, Raman spectroscopy show different copper phase and the highest intensity peak at 220 cm −1 , due to the cuprous oxide in all sample used to distinct chemical fingerprint for a particular molecule or material. Many of metal oxide bond was study by FTIR to clarify the compositional and chemical properties of the prepared samples. Optical characteristic with different absorption peaks of thin film show decrease in the band gap from (2.8–2.4 eV) as the reaction time increase. PL measurement used also to determine the band gap energy of the prepared thin film which found to be agreement with UV–Vis, and the band gap value is (2.7, 2.6, 2.5, 2.3, and 2.3 eV), respectively. Increasing in the surface roughness from (3.637–25.16 nm), and in the root mean square from (5–29.39 nm), and grain size with increasing the reaction time from (24–72 h), respectively, was measured by using AFM technique. Different morphologies were showed with increasing the reaction time, spherical and truncated octahedral in different type was obtained by field emission-scanning electron microscope (FE-SEM) as the particles subject to transformation caused the preparing agglomerated crystallites. The electrical characteristic was analysis use DC measurement to measure the activation energy which varied with reaction time. The figure of merit analysis shows that the copper oxidation state to obtain cuprous oxide (Cu 2 O) is mainly obtained at the 48 h-reaction time. The used of copper nano powder in hydrothermal method without adding any auxiliary material the main aim of this research.

Surface‐enhanced resonance Raman scattering in partially oxidized thin copper film

Effect of solution concentration on surface morphology, chemical composition and photoresponse of CuO/Cu 2 O composite thin films grown by hydrothermal synthesis

Synthesizing robust cuprous oxide film with adjustable morphologies as surface-enhanced Raman scattering substrate by copper anodization

Effects of oxidation on the localized surface plasmon resonance of Cu nanoparticles fabricated via vacuum coating

Investigation of synchrotron X-ray induced oxidation of Ag–Cu thin-film

Oxidation Kinetics of Nanoscale Copper Thin Films at Low Temperature Characterized by Sheet Resistance and Optical Transmittance

XAFS and HAXPES analyses of the oxidation state of a copper surface buried under a phenolic resin nanofilm

Surface-Enhanced Raman-Scattering (sers) Study on the Air Oxidation of Copper and Its Reactions with Azoles

Spectral analysis of oxidation on localized surface plasmon resonance of copper nanoparticles thin film

Study on the electronic and structural properties of oxidized copper films

Deposition time effect on copper oxide nano structures, an analysis study using chemical method

Electrochemically generated CuI and CuSCN nanocrystals on Cu surfaces as Raman enhancing substrates

Temporal-Spatial Measurement of Surface Morphological Evolution Time in Nanosecond Laser Irradiation on the Copper Film

Magnetic properties in a partially oxidized nanocomposite of Cu-CuCl

Identification of Copper Surface Index by Optical Contrast

Crystal-plane-dependent Redox Reaction on Cu Surfaces

An in Situ Method for Characterizing the Kinetics of the Oxidation Process of Copper Thin Films Via Sheet Resistance

Nanoscale characterization of the heterogeneous interfacial oxidation layer of graphene/Cu based on a SEM electron beam induced reduction effect

Modulating surface chemistry of copper oxides through annealing environment for enhanced selective HMF oxidation: A DFT-electrochemical approach

Surface-enhanced Raman scattering studies of Cu/Cu2O Core-shell NPs obtained by laser ablation

Investigating the oxidative synthesis of copper oxide nanowires: Wettability and photoelectrochemical insights